User manual CORONA CONCEPTS CREEKSIDE CABIN

[. . . ] If you should have any questions or comments during the construction of your Creekside Cabin, do not hesitate to call us at (800) 253-7150. We are here to answer all of your questions as well as to hear your comments about our product. Feed back from you, the customer, is our only indication of how we're doing our job. Have fun and thank you for purchasing our product! This kit was designed with effciency in mind. The Creekside Cabin L) ASSEMBLY OF ROOF ? [. . . ] Position and glue a porch column at the end of the railing centered and in line with the posts. With the porch roof face down, position and glue the column support centered from side to side and 1" from the front side. Rest the porch roof on the fourteenth log of the house and glue in place. The porch columns should rest against the front edge of the column support on the underside of the roof and should be glued in place. Finishing Touches Finishing your dollhouse is only limited by your imagination. Paint, wallpaper, stain and stucco are only a few of the items you can be creative with. Use the wood fill to smooth joints between tabs and slots and on corner seams. Satin finish latex house paint will give a better result than either flat or gloss finish. Be sure to check your local craft shop for other decorative items such as siding, floor tiles, carpet, electrification kits, furniture, etc. 5. Position and glue the porch brackets in place using the K) FRONT DOOR AND DOOR TRIM ?R&P three pieces of exterior front door trim from sheets #1 and #1A. Position and glue the exterior door trim pieces flush to the door opening. Position and glue the interior door trim pieces flush to the door opening. Position and glue the four door planks side by side with top and bottom edges flush. Using the photo as a guide, position and glue the door braces to the front side of the door. Glue the door into position in the front door opening. The Creekside Cabin 3 8 The Creekside Cabin Assembly Instructions H) STAIRS AND 2ND FLOOR RAILINGS ?Insert the stair assembly into place by putting down through the opening from the second floor. R&P two stair railings ­ one from sheet #1 and one from sheet #5. Invert these assemblies and glue them into place around the stair opening on the second floor. Invert this assembly and glue the end against the fireplace wall approximately 1" in from the back. #2 #1 PLANK SUPPORT A) ASSEMBLY OF ROCKING CHAIR ?R&P two chair sides, chair seat, four chair backs, and two chair arms all located on sheet #6. Glue the two chair sides to the chair seat keeping front and back edges flush. Evenly space the chair backs between the chair sides, placing the curved back piece at the top and glue in position. [. . . ] Each ¾" square should be flush with the log you are gluing it to. This forces the back wall tight to the side wall and eliminates the need to actually glue the walls together. 6 The Creekside Cabin 1. With the side walls face down, position and glue the first floor supports in place. Keep them flush with the bottom edge of the wall and centered from side to side. [. . . ]