User manual CORONA CONCEPTS WILLOW

[. . . ] Corona Concepts presents The Willow All Wood Dollhouse Instructions and Assembly Guide Introduction In Short . Since the first tab and slot die-cut dollhouse kits arrived on the scene in the mid 1970's, their design and styling concepts have evolved swiftly. However, complexity of construction has always accompanied the great design and styling. As pioneers in the early days of the die-cut dollhouse industry, the designers for Corona Concepts have utilized a simpler method for building dollhouses. [. . . ] Glue mantle top to mantel bottom and glue this assembly to top edge of fireplace front keeping back edges flush. R&P right side chimney front (5), two chimney sides (1), chimney front inside (5), chimney back (1), chimney back 4 The Willow inside (5), chimney top (4), four chimney top sides (4), two chimney trims (5), four chimney flute fronts (10), and four chimney flute sides (10). Using tabs and slots as guides, glue the chimney sides to the chimney front. Position the chimney front inside piece on the inside of the chimney covering the two long "slots". Position and glue the chimney back inside piece to the chimney back in the same manner. Glue the chimney top to the chimney front assembly keeping it flush with the top edge of front. Sandwich two chimney sides together by gluing and glue to each side if chimney. Position chimney trims on front and back keeping top edges flush - glue. Glue two chimney flute sides to two flute fronts, (making a little box). D) ASSEMBLY OF FIRST FLOOR FIREPLACE/BOOKCASE WALL UNIT AND LEFT SIDE CHIMNEY 1. R&P wall unit front (3), four bookcase sides (3), two wall unit sides (3), ten bookcase shelves (3), two bookcase trims (3), two bookcase door trims (3), four bookcase doors (3), (these can either be punched out and hinged, or left in place), fireplace mantel top (3), fireplace mantel bottom (3), two mantel supports(8)two fireplace hearth floor pieces(3), four fireplace hearth sides(9), and the fireplace hearth top. Using two bookcase sides and tow bookcase shelves, create a "box". Position three shelves however you choose inside this "box" and glue in place. Top and bottom edges should be flush - glue, Repeat for second bookcase. Turn wall unit over, glue bookcase trims in place and then glue on bookcase doors and door trims. With the hearth floor laying face up, glue the four hearth sides on TOP of the floor, keeping outside edges flush, then glue the hearth top over the sides, again keeping outside edges flush. Be sure to dry fit these pieces before gluing to be sure you have them positioned properly. This assembly now needs to be glued to fireplace opening in the wall unit front 5. R&P left side chimney front (4), six chimney sides (4), chimney front inside (5), chimney back (5), The Willow 5 chimney back inside (5), chimney top (4), four chimney top sides (4), two chimney trims (5), four chimney flute fronts (10), and four chimney flute sides (10). Using tabs and slots as guides, glue the chimney sides to the chimney front. Glue them with back edges flush, the front and bottom edges will hang over a little. Position the chimney front inside piece on the inside of the chimney covering the two long "slots". [. . . ] Before you can begin to put the roof on, you need to carefully "pop" off both chimney assemblies. R&P front roof (4), back roof (3), eight pieces of gable trim (2). Position and glue gable trims in place The four smaller pieces should be placed directly over the larger pieces along the bottom edge. Position the longer foundation piece vertically in the center of the house and glue. [. . . ]