User manual DE DIETRICH DRS1137I

[. . . ] Garments treated or contaminated with flammable cleaning sprays or liquids such as petrol, cooking oil or aerosol sprays must not be put in this machine. Must not be allowed to collect on the floor around the outside of the machine. Always allow the dryer to complete the cool down period before removing the laundry. If the supply cord on this appliance is damaged, it must be replaced by a special cord which is only available from GIAS Service or an authorised dealer. [. . . ] 5 inches) between the sides rear and base of the machine and the surrounding walls , cabinets and floor. To ensure adequate ventilation the space between the bottom of the machine and the floor must not be obstructed. Prevent items from falling or collecting behind and beneath the dryer as these may obstruct the air inlets and outlets. Before using the dryer for the first time wipe the inside of the drum and door with a damp cloth. Make sure that the laundry you are going to dry is suitable for drying in a tumble dryer, as shown by the care symbols on each item. Place clothes loosely in the drum to make sure that they don't get tangled. Warning: Do not overload the drum, large items when wet can exceed the maximum admissible clothes load (for example: sleeping bags, duvets). A) By care symbols On the collar or inside seam: Suitable for tumble drying. B) By amount and thickness Whenever the load is bigger than the dryer capacity, separate clothes according to thickness (e. NEVER put dripping wet items into the tumble dryer, this may damage the appliance and waste time and efficiency. Woollens, silk, delicate fabrics, nylon stockings, delicate embroidery, fabrics with metallic decorations, garments with PVC or leather trimmings, training shoes, bulky items such as sleeping bags, etc. Garments may also become stiffened when dried outside on a washing line or inside on radiators. The drying cycle will then go into the cooldown period and the `COOLING' indicator will light. after 10 minutes of cooldown the drum will stop rotating automatically. For small loads and separate items or pre-dried fabrics with low moisture content, utilise the timed programmes. Set the programme between 30 and 75 minutes depending upon the load size and dryness required and select high or low heat depending upon the fabric type. If this is not carried out the dryer will only operate for 10 minutes before going into cooldown. (ii) If the sensor does not operate, for example when a load is too large or too wet to tumble dry, the dryer will automatically go into cooldown after 180 minutes. The dryer can be set to start up to 9 hours after the program has been set. To set the time delay option press and release the `START DELAY' button until the required delay (shown in hours) appears on the display and then press the `START' button. The delay can be changed at any time simply by pressing the button until the new figure appears on the display. If there is an interruption to the electricity supply the time delay will be lost and so will have to be re-set when the power is restored. [. . . ] To prevent the door sticking, periodically clean the door gasket with a `non-scratch cream cleaner. ' Over a period of time deposits from the water may form over the sensor plate (found inside the drum below the door opening). This sensor plate can be cleaned with a soft cloth and a dilute vinegar solution. Ensure that any excess is removed or the vinegar solution may stain clothing. [. . . ]