User manual DERBI ATLANTIS CITY 50 2T

[. . . ] Sociedad Unipersonal offers you our thanks for the confidence you place in us in your purchase of your new model ATLANTIS. This manual will explain the principal details of how to maintain this scooter so you can get a longer duration with a minimum cost and the best performance. DERBI's quality will take care of everything else, we are sure that you will get complete satisfaction with the use of this vehicle, with the original spare parts and a National web of more than four thousand agents and shops. Due to its criterion of constant improvement of its products, DERBI - NACIONAL MOTOR, S. [. . . ] For any other adjustment of the carburettor we recommend that you should ask your official DERBI Service Agent. Adjustment of the idle speed must be carried out when the engine is hot. Cleaning the air filter The air filter foam is to be found in the filter box which is located on the left the crankcase (1). NOTE: If the filter foam becomes blocked with dust, resistance to the intake of air will increase, and this will cause a reduction in the power output and an increase in the fuel consumption. It is recommended to clean the filter foam every 5, 000 kilometres, following the steps below: - Unscrew the screws securing the filter box cover. - Squeeze out the cleaning fluid pressing a number of times between the palms of the hands. Do not fold or wring out the filter, since to do so would cause it to tear. - Submerge the filter foam in a container filled with AGIP FILTER OIL and then press a number of times between the palms of the hands to squeeze out the excess oil. - Once the filter foam is clean, fit it again, following the reverse order to disassembly. - It is also extremely important to clean the entire secondary airway system, which is located on the right-hand side of the engine (2). This operation should be performed at an Official Derbi Service Agent. - Both before and during the cleaning process, examine the air filter foam thoroughly, and if any defects are found, do not fail to replace it with a new one. - If you drive on dusty roads, the air filter foam should be cleaned more frequently. The fuse If the fuse in the electrical system has to be changed because it has blown, be sure to replace it with one of equal amperage, that is, 4 amps. The fuse is located inside the battery compartment; to change it, take it out of its support and put the new one in its place. Never use a fuse higher than 4 amps, because to do so can cause damage to the electrical system. If the fuse blows again within a short period of time, consult your Official DERBI Service Agent. Battery installation instructions - Extract the three screws from the lower saddle fairing. Maintenance of the battery Good maintenance of the battery should include: - Always keep the water level between the upper and lower marks on the front of the battery case. - Keep the upper surface of the battery completely clean and dry and free of corrosive materials; the terminals should be kept clean and greased so as to avoid corrosion. - When not in use, the battery will dis- This average increases with the temperature. The battery should be given a top-up charge every month to compensate for this loss. [. . . ] Do not replace the drain plug, but instead plug the drain hole with clean cloth. Pour in through the spark plug hole 10 to 15 cc of anti-corrosion oil through the spark plug hole. - Grease all metal parts with an anti-oxidant grease; nowadays there are sprays on the market which are perfect for this purpose. - Cover the scooter with a plastic sheet, to prevent the build up of dust. [. . . ]