User manual DERBI SENDA RSM 125 4T BAJA

[. . . ] DERBI NATIONAL MOTOR, corporation, would like to thank you the confidence in choosing this model SENDA R/SM 125 4T Baja This manual will explain the principal details of how to maintain this motorcycle, so you can get a longer duration with a minimum cost and the best performance. DERBI's quality will take care of everything else, we are sure that you will get complete satisfaction with the use of this vehicle, with the original spare parts and a National web of more than four thousand agents and shops. Due to its criterion of constant improvement of its products, DERBI - NACIONAL MOTOR, S. Sociedad Unipersonal reserves the right to introduce any modifications it considers suitable, without prior notice. [. . . ] The engine oil quality is the main factor to obtain the best results for the features designed in the vehicle and, therefore, it is important to follow the indications and operations described in the PROGRAMMED MAINTENANCE chart. The use of a different oil can affect the engine performance and usage. The use of any electrical ignition devices and spark plugs not specified can seriously damage the engine. The foam element is inside the filter housing located at the left side of the motorcycle. OBSERVATION: If the foam element is stucked with dust, it will increase the intake resistence with a result of a loss of power and with aa increase of fuel consumption. - Remove the side cover from the left side (1) - Removed the foam element cover box and securing bolts. Submerge the filter inside the solvent until it gets clean - Removed the cleaner fluid by squeezing it several times with the palm of your hands. - Place the foam element in a recipient filled with filter oil and then squeeze it with the palm of your hands until the oil is removed completely. - Once the foam element is clean, install it in the reverse order of removal. Before and during the cleaning procedure check for damages in the foam element, if it is damaged, replace it with a new one. If you drive under dusty conditions, you must clean the air foam filter frequently. Make sure that the air foam filter element is under correct conditions. The front brake fluid tank is located in the handlebar, near the throttle grip. Follow the steps indicated in this procedure: - Place the vehicle over the central stand and with the handlebar centered. In case that the level is lower than the minimun, refer to the nearest Distributor DERBI to perform a control of the brake system. Refilling the fluid Use only the specified brake fluid DOT 4 Specified brake fluid: BRAKE FLUID DOT 4 Follow the next operations: 1. Fill up the fluid at the correct level, use only the specified liquid. In case of accidental contact, clean immediately with water the affected parts. Make sure there is no leakage in the circuit and check that the hoses and the unions are not damaged and also they shoul not be twisted. The adjustment of the brake pump has been done at the factory; if necessary, go to your nearest Dealer DERBI. It is forbidden to change these adjustments, because it can seriously damage the brake system. The brake circuit fluid is highly corrosive, avoid contact with the body, painted parts and / or any plastic parts. [. . . ] The vehicle needs to be clean · Never use a high pressure jet of water, it can damage all the electrical devices. Never wash the vehicle under the sun, even during the summer season, because when the soap dries once applied over the hot body before it is rinsed, it will damage the paint. To avoid the loss of gloss, never use rags soaked in gasoline, diesel fuel or naphta to wash the painted surfaces or the plastic materials. Symptom Engine does not start Possible causes - Fuel valve closed or empty tank; - Spray, carburetor body or valve dirty or stuck - Irregular or weak ignition Procedure - open the fuel valve or refill the fuel tank. [. . . ]