User manual DEWALT D21002

[. . . ] Use a face or dust mask whenever the operations may produce dust or flying particles. If these particles might be considerably hot, also wear a heat-resistant apron. 6 Guard against electric shock Prevent body contact with earthed surfaces (e. ) , electric safety can be improved by inserting an isolating transformer or a (FI) earth-leakage circuit-breaker. [. . . ] 15 Unplug tool Switch off and wait for the tool to come to a complete standstill before leaving it unattended. Unplug the tool when not in use, before changing any parts of the tools, accessories or attachments and before servicing. 16 Avoid unintentional starting Do not carry the tool with a finger on the switch. 18 Store idle tools When not in use, tools must be stored in a dry place and locked up securely, out of reach of children. 19 Maintain tools with care Keep the tools in good condition and clean for better and safer performance. Keep all handles and switches dry, clean and free from oil and grease. 20 Repairs This tool is in accordance with the relevant safety regulations. Repairs should only be carried out by qualified persons using original spare parts; otherwise this may result in considerable danger to the user. Your DEWALT tool is double insulated in accordance with EN 50144; therefore no earth wire is required. Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Never connect the live (L) or neutral (N) wires to the earth pin marked E or . For 115 V units with a power rating exceeding 1500 W, we recommend to fit a plug to BS4343 standard. Variable speed switch Lock-on button Forward/reverse slider Keyed chuck (D21002) Keyless chuck (D21008) 5 Sleeve 6 Chuck key (D21002) 1 2 3 4 If an extension cable is required, use an approved extension cable suitable for the power input of this tool (see technical data). [. . . ] Your DEWALT Power Tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning. GUARANTEE Cleaning Keep the ventilation slots clear and regularly clean the housing with a soft cloth. Take your tool to an authorized DEWALT repair agent where it will be disposed of in an environmentally safe way. [. . . ]