User manual DEWALT D21620K

[. . . ] Never use the cord for carrying, pulling or unplugging the power tool. E When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. 3 Personal safety a Stay alert, watch what you are doing and use common sense when operating a power tool. [. . . ] Do not use the machine on the same workpiece on which electric welders are being used. Do not use liquid cutting fluids while drilling vertically or overhead. Do not pour cutting fluid into the reservoir while it is mounted in the bracket. Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. If an extension cable is required, use an approved extension cable suitable for the power input of this machine (see technical data). Always check that the power supply corresponds to the voltage on the rating plate. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Brown is for Live (L) (2), blue is for Neutral (N) (4) and green/yellow is for Earth (E). Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the leads are correctly fixed at the terminal screws. Remove any particles that will obstruct full contact between the magnetic stand and the mounting surface. B) The quick-release feed handle (4) can be mounted in one simple operation both to the left and the right of the machine. Keep the button (11) depressed while inserting the hub shaft into the hole (12). Never connect the live (L) or neutral (N) wires to the earth pin marked E or . For 115 V units with a power rating exceeding 1500 W, we recommend to fit a plug to BS4343 standard. Hold the guard (7) in front of the tool holder, aligning the slots in the holes with the holes in the machine. Fit the screw (13) into the hole (14) located in the front of the frame. Fit a knob (15) into each of the holes (16) located at both sides of the frame. [. . . ] drilling with annular cutters · Annular cutters only cut material at the periphery of the hole, rather than converting the entire hole to shavings. As a result the energy required to make a hole is lower than for a twist drill. When drilling with an annular cutter, it is not necessary to drill a pilot hole. If you are not completely satisfied with the performance of your DEWALT tool, simply return it within 30 days, complete as purchased, to the point of purchase, for a full refund or exchange. [. . . ]