User manual DEWALT D23700

[. . . ] There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. E When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. [. . . ] Kickback could cause the saw to jump backwards, but kickback forces can be controlled by the operator, if proper precautions are taken. B When blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from the work or pull the saw backward while the blade is in motion or kickback may occur. investigate and take corrective actions to eliminate the cause of blade binding. C When restarting a saw in the workpiece, centre the saw blade in the kerf and check that saw teeth are not engaged into the material. If saw blade is binding, it may walk up or kickback from the workpiece as the saw is restarted. D Support large panels to minimise the risk of blade pinching and kickback. Supports must be placed under the panel on both sides, near the line of cut and near the edge of the panel. F Blade depth and bevel adjusting locking levers must be tight and secure before making cut. If blade adjustment shifts while cutting, it may cause binding and kickback. G Use extra caution when making a , , plunge cut" into existing walls or other blind areas. Safety instructions for saws with a pendulum blade guard a Check lower guard for proper closing before each use. Do not operate the saw if lower guard does not move freely and close instantly. Raise the lower guard with the retracting handle and make sure it moves freely and does not touch the blade or any other part, in all angles and depths of cut. If the guard and the spring are not operating properly, they must be serviced before use. Lower guard may operate sluggishly due to damaged parts, gummy deposits, or a build-up of debris. C Lower guard should be retracted manually only for special cuts such as , , plunge cuts" and , , compound cuts. " Raise lower guard by retracting handle and as soon as blade enters the material, the lower guard must be released. D Always observe that the lower guard is covering the blade before placing saw down on bench or floor. An unprotected, coasting blade will cause the saw to walk backwards, cutting whatever is in its path. Be aware of the time it takes for the blade to stop after switch is released. Additional safety instructions for all saws with riving knife a Use the appropriate riving knife for the blade being used. [. . . ] Cleaning Keep the ventilation slots clear and regularly clean the housing with a soft cloth. If you need maintenance or service for your DEWALT tool, in the 12 months following purchase, it will be undertaken free of charge at an authorized DEWALT repair agent. Take your tool to an authorized DEWALT repair agent where it will be disposed of in an environmentally safe way. If your DEWALT product becomes defective due to faulty materials or workmanship within 12 months from the date of purchase, we guarantee to replace all defective parts free of charge or, at our discretion, replace the unit free of charge provided that: · For the location of your nearest authorized DEWALT repair agent, please use the appropriate telephone number on the back of this manual. [. . . ]