User manual DEWALT DC308KL

[. . . ] Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. D Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. [. . . ] Take the time to thoroughly read and understand this manual prior to operation. Read instruction manual before use Do not probe with conductive objects Your jigsaw DC308 has been designed for professional cutting of wood, steel, aluminium, plastic and ceramic material. 1 Variable speed switch 2 Safety lock 3 Sawdust blower control 4 Blade latch 5 Finger guard 6 Blade holder Never use a light socket. Never connect the live (L) or neutral (N) wires to the earth pin marked E or . Always check that the battery pack voltage corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to that of your mains. Use an approved extension cable suitable for the power input of your charger (see technical data). Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Always switch off the tool before inserting or removing the battery pack. A) To fit the battery pack (11), line it up with the receptacle on the tool. Slide the battery pack into the receptacle and push until the battery snaps into place. To remove the battery pack, push the release button (12) while at the same time pulling the battery pack out of the receptacle. If the mains is functioning but the battery pack does not charge, take your charger to an authorized DEWALT repair agent. whilst charging , the charger and the battery pack may become warm to touch. Do not charge the battery pack at ambient temperatures < 4 °C or > 40 °C. To charge the battery pack (11), insert it into the charger (13) as shown and plug in the charger. the red charging indicators (14) will blink according to the state of charge of the battery pack. [. . . ] If you are not completely satisfied with the performance of your DEWALT tool, simply return it within 30 days, complete as purchased, to the point of purchase, for a full refund or exchange. If you need maintenance or service for your DEWALT tool, in the 12 months following purchase, it will be undertaken free of charge at an authorized DEWALT repair agent. If your DEWALT product becomes defective due to faulty materials or workmanship within 12 months from the date of purchase, we guarantee to replace all defective parts free of charge or, at our discretion, replace the unit free of charge provided that: The product has not been misused. For the location of your nearest authorized DEWALT repair agent, please use the appropriate telephone number on the back of this manual. [. . . ]