User manual DEWALT DC310KL

[. . . ] TILTÆNKT BRUG De heavy duty rundsave model DC300/310 er designet til professionel brug til savning på forskellige arbejdssteder (byggeplad-ser). Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional power tool users. CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. CAUTION: Used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in property damage. [. . . ] An unprotected, coasting blade will cause the saw to walk backwards, cutting whatever is in its path. Be aware of the time it takes for the blade to stop after switch is released. Additional safety instructions for circular saws Wear ear protectors. Use only the blades specified in this manual, complying with EN 847-1. Additional safety instructions for battery packs and chargers Make sure that the battery pack is dry and clean before inserting it into the charger. have any damaged or defective cords replaced by an authorised DEWALT repair agent. Charge only battery packs with the ratings as specified in this manual. Always follow the instructions in the back of this manual for battery pack disposal. Never connect the live (L) or neutral (N) wires to the earth pin marked E or . Using an extension cable Electrical safety the electric motor has been designed for one voltage only. Always check that the battery pack voltage corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to that of your mains. Use an approved extension cable suitable for the power input of your charger (see technical data). WARNING: Always switch off the tool before inserting or removing the battery pack. A) To fit the battery pack (13), line it up with the receptacle on the tool. Slide the battery pack into the receptacle and push until the battery snaps into place. To remove the battery pack, push the release button (14) while at the same time pulling the battery pack out of the receptacle. If the mains is functioning but the battery pack does not charge, take your charger to an authorized DEWALT repair agent. whilst charging , the charger and the battery pack may become warm to touch. CAUTION: Do not charge the battery pack at ambient temperatures < 4 °C or > 40 °C. To charge the battery pack (13), insert it into the charger (15) as shown and plug in the charger. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. [. . . ] Should you find one day that your DEWALT product needs replacement, or if it is of no further use to you, do not dispose of it with household waste. Separate collection of used products and packaging allows materials to be recycled and used again. re-use of recycled materials helps prevent environmental pollution and reduces the demand for raw materials. Local regulations may provide for separate collection of electrical products from the household, at municipal waste sites or by the retailer when you purchase a new product. [. . . ]