User manual DEWALT DC330KB

[. . . ] Never use the cord for carrying, pulling or unplugging the power tool. E When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. 3 Personal safety a Stay alert, watch what you are doing and use common sense when operating a power tool. [. . . ] If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly ratedfuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Your jigsaw DC330 has been designed for professional cutting of wood, steel, aluminium, plastic and ceramic material. 1 Variable speed switch 2 Safety lock 3 Sawdust blower control 4 Blade latch 5 Finger guard 6 Blade holder 7 Guide roller To charge the battery pack (11), insert it into the charger (13) as shown and plug in the charger. The battery pack can be removed at any time or left in the connected charger for a longer period of time (with a maximum of 14 days). Never connect the live (L) or neutral (N) wires to the earth pin marked E or . inserting and removing the battery pack · Insert the battery pack into the grip until it clicks in place. To remove the battery pack, press the two release buttons (12) simultaneously and pull the pack out of the grip. Without the protective cap in place, loose metal objects could short circuit the contacts, causing a fire hazard and damaging the battery pack. Take off the protective cap (15) before placing the battery pack (11) in the charger or tool. Place the protective cap over the contacts immediately after removing the battery pack from the charger or tool. Make sure the protective cap is in place before storing or carrying a detached battery pack. Automatic refresh The automatic refresh mode will equalize or balance the individual cells in the battery pack at its peak capacity. Battery packs should be refreshed overnight after every 10th charge/discharge cycle or whenever the pack no longer delivers the same amount of work. To refresh your battery pack, place the battery in the charger as usual. Use an approved extension cable suitable for the power input of your charger (see technical data). Always switch off the tool before inserting or removing the battery pack. A) When charging the battery pack for the first time, or after prolonged storage, it will only accept an 80% charge. After several charge and discharge cycles, the battery pack will attain full capacity. [. . . ] If you are not completely satisfied with the performance of your DEWALT tool, simply return it within 30 days, complete as purchased, to the point of purchase, for a full refund or exchange. If you need maintenance or service for your DEWALT tool, in the 12 months following purchase, it will be undertaken free of charge at an authorized DEWALT repair agent. If your DEWALT product becomes defective due to faulty materials or workmanship within 12 months from the date of purchase, we guarantee to replace all defective parts free of charge or, at our discretion, replace the unit free of charge provided that: · For the location of your nearest authorized DEWALT repair agent, please use the appropriate telephone number on the back of this manual. Alternatively, a list of authorized DEWALT repair agents and full details on our after-sales service are available on the Internet at www. [. . . ]