User manual DEWALT DC750KA

[. . . ] Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional power tool users. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. [. . . ] Disconnect the charger from the outlet before attempting any cleaning. The automatic refresh mode will equalise or balance the individual cells in the battery pack at its peak capacity. Battery packs should be refreshed weekly or whenever the pack no longer delivers the same amount of work. To refresh your battery pack, place the battery in the charger as usual. When the charger detects a battery that is too hot or too cold, it automatically starts a Hot/Cold Pack Delay, suspending charging until the battery has reached an appropriate temperature. DEEP DISCHARGE PROTECTION The battery pack is protected against deep discharging when it is used in the tool. Your DE9116 charger accepts DEWALT NiCd and NiMH battery packs ranging from 7. These chargers require no adjustment and are designed to be as easy as possible to operate. When ordering replacement battery packs, be sure to include catalog number and voltage. consult the chart at the end of this manual for compatibility of chargers and battery packs. Before using the battery pack and charger, read the safety instructions below. Plug the charger (k) into an appropriate outlet before inserting battery pack. The pack is fully charged and may be used at this time or left in the charger. Toxic fumes and materials are created when lithium ion battery packs are burned. If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte is composed of a mixture of liquid organic carbonates and lithium salts. Without the protective cap in place, loose metal objects could short circuit the contacts, causing a fire hazard and damaging the battery pack. Take off the protective battery cap (o) before placing the battery pack in the charger or tool (fig. Place the protective cap over the contacts immediately after removing the battery pack from the charger or tool (fig. WARNING: Make sure the protective battery cap is in place before storing or carrying a detached battery pack. The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold. [. . . ] WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush. WARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this tool could be hazardous. [. . . ]