User manual DEWALT DC920KB

[. . . ] Never use the cord for carrying, pulling or unplugging the power tool. E When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. 3 Personal safety a Stay alert, watch what you are doing and use common sense when operating a power tool. [. . . ] Do not incinerate the battery pack The package contains: 1 Cordless midhandle driver/drill 1 Side handle 1 Charger 2 Battery packs (KB models) 1 Kitbox 1 Instruction manual 1 Exploded drawing Note: Battery packs and chargers are not included with N-models. Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. Always check that the battery pack voltage corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to that of your mains. Your DEWALT charger is double insulated in accordance with EN 60745 & EN 60335. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. 1 Variable speed switch 2 Forward/reverse slider 3 Keyless chuck/auto spindle lock 4 Mode selector/torque adjustment collar 5 Collar settings 6 Three-gear selector 7 Bit holder 8 Grip 9 Side handle 10 Battery pack Charger Your DE9130 charger accepts DEWALT NiMH and NiCd battery packs ranging from 7. The battery pack can be removed at any time or left in the connected charger for a longer period of time (with a maximum of 14 days). Inserting and removing the battery pack Insert the battery pack into the grip until it clicks in place. To remove the battery pack, press the two release buttons (11) simultaneously and pull the pack out of the grip. Without the protective cap in place, loose metal objects could short circuit the contacts, causing a fire hazard and damaging the battery pack. Take off the protective cap (14) before placing the battery pack (10) in the charger or tool. Place the protective cap over the contacts immediately after removing the battery pack from the charger or tool. Make sure the protective cap is in place before storing or carrying a detached battery pack. Automatic refresh The automatic refresh mode will equalize or balance the individual cells in the battery pack at its peak capacity. Battery packs should be refreshed overnight after every 10th charge/discharge cycle or whenever the pack no longer delivers the same amount of work. [. . . ] At the end of its technical life, discard it with due care for our environment: Run the battery pack down completely, then remove it from the tool. If you are not completely satisfied with the performance of your DEWALT tool, simply return it within 30 days, complete as purchased, to the point of purchase, for a full refund or exchange. If you need maintenance or service for your DEWALT tool, in the 12 months following purchase, it will be undertaken free of charge at an authorized DEWALT repair agent. If your DEWALT product becomes defective due to faulty materials or workmanship within 12 months from the date of purchase, we guarantee to replace all defective parts free of charge or, at our discretion, replace the unit free of charge provided that: The product has not been misused. [. . . ]