User manual DEWALT DW411

[. . . ] Properly maintained tools, with sharp cutting edges are less likely to bind and are easier to control. ⷠCheck for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tools operation. ⷠUse only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool, may become hazardous when used on another tool. [. . . ] " These cords are rated for outdoor use and reduce the risk of electric shock. minimum Gage for Cord Sets Volts Total Length of Cord in Feet 120V 0-25 26-50 51-100 101-150 240V 0-50 51-100 101-200 201-300 Ampere Rating More Not more AWG ThanThan 0 6 18 16 16 14 6 - 10 18 16 14 12 PERSONAL SAFETY · Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury, · dress properly. A wrench or a key that is left attached to a rotating part of the tool may result in personal injury. Be sure your power supply agrees with the nameplate marking (Volts, 120 AC only). A Voltage decrease of more than 10% will cause loss of power and overheating. All tools DEWalt tools are factory tested; if this tool does not operate, check the power supply. For normal operations, assemble the abrasive paper to your unit as follows. Release clamp by pulling up on clamp lever and disengaging it from the tab on the base plate. Insert the 4-1/2" edge of the abrasive paper under the front paper clamp, as shown in Figure 3 until it hits the paper limiting ribs shown in the figure. Close the front paper clamp and hook it into the lock position behind the tab on the base plate. If you are using the dust extraction feature, perforate the sand- paper with the provided paper punch as shown in Figure 5. To turn the unit on, depress the side of the dust protected switch that corresponds to the symbol "I". To turn the tool off, depress the side of the switch that corresponds to the symbol "O". A paper punch is provided with your sander to let you perforate regular sandpaper to make dust collection possible. To perforate your sandpaper, install the sandpaper on the tool as instructed in this manual. With the sander turned off and unplugged, place the paper punch on the paper so that the tabs at the edges of the punch are against any two adjacent sides of the sanding pad, as shown. Press the punch against the pad so that the 8 points penetrate the paper, as shown in Figure 6. An alternate method of perforating the paper is to fasten the punch down to a suitable work surface and press the sander (with the paper attached) down on the punch. To use the dust collecting system, lower the plastic end of the collection bag over the flange and push it down as far as it will go, as shown. To empty the dust collection bag, simply lift it up, off of the sander and empty over a trash receptacle. [. . . ] All toys, washable furniture and utensils used by children should be washed thoroughly before being used again. Keep your machine as clean as possible by wiping with a clean cloth and blowing through it with air after every 5 hours of use. Overloading will result in a considerable reduction in speed and efficiency and the unit will become hot. In this event, run sander at a "no load" condition for a minute or two. [. . . ]