User manual DEWALT DW433K

[. . . ] If these particles might be considerably hot, also wear a heat-resistant apron. 6 Guard against electric shock Prevent body contact with earthed surfaces (e. ) , electric safety can be improved by inserting an isolating transformer or a (FI) earth-leakage circuit-breaker. 10 Connect dust extraction equipment If devices are provided for the connection of dust extraction and collection facilities, ensure that these are connected and properly used. [. . . ] 19 Maintain tools with care Keep the tools in good condition and clean for better and safer performance. Keep all handles and switches dry, clean and free from oil and grease. 20 Repairs This tool is in accordance with the relevant safety regulations. Repairs should only be carried out by qualified persons using original spare parts; otherwise this may result in considerable danger to the user. Pay special attention to the following: 1 Whenever possible, use a vacuum extractor for dust collection. 2 Take special care when sanding paint which is possibly lead based: · Do not let children or pregnant women enter the work area. All persons entering the work area should wear a mask specially designed for protection against lead paint dust and fumes. Take the time to thoroughly read and understand this manual prior to operation. Always check that the power supply corresponds to the voltage on the rating plate. Your DeWALT tool is double insulated in accordance with EN 50144; therefore no earth wire is required. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DeWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Check for damage to the tool, parts or accessories which may have occurred during transport. Turn the clamping lever (7) clockwise until it is in the release position. Place a new sanding belt making sure that the arrow on the inside of the sanding belt points in the same direction as the arrow on the machine. Turn the clamping lever counter-clockwise until it is in the clamp position. Switch the machine on and turn the belt centring knob (8) until the sanding belt is centred on the roller (6). C) The position of the front handle can be adjusted for optimum control. [. . . ] Excessive pressure does not improve the sanding effect, but only results in an increased load on the machine and causes the abrasive to tear. Cleaning Keep the ventilation slots clear and regularly clean the housing with a soft cloth. Take your tool to an authorized DEWALT repair agent where it will be disposed of in an environmentally safe way. If you are not completely satisfied with the performance of your DEWALT tool, simply return it within 30 days, complete as purchased, to the point of purchase, for a full refund or exchange. [. . . ]