User manual DEWALT DW505K

[. . . ] 6 Store idle tools When not in use, Power Tools must be stored in a dry place and locked up securely, out of reach of children. Preferably wear rubber gloves and non-slip footwear when working outdoors. 8 Wear safety goggles Also use a face or dust mask in case the operations produce dust or flying particles. 9 Beware of maximum sound pressure Take appropriate measures for the protection of hearing if the sound pressure of 85 dB(A) is exceeded. [. . . ] 19 Check for damaged parts Before using the tool, carefully check it for damage to ensure that it will operate properly and perform its intended function. Check for misalignment and seizure of moving parts, breakage of parts and any other conditions that may affect its operation. Have damaged guards or other defective parts repaired or replaced as instructed. 20 Have your tool repaired by an authorized DEWALT repair agent This Power Tool is in accordance with the relevant safety regulations. Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. 1 Variable speed switch 2 Lock-on button 3 Forward/reverse slider 4 Two gear selector 5 Mode selector (DW500/DW505) 6 Side handle 7 Depth adjustment rod 8 Keyed chuck 8 Keyless chuck 9 Sleeve 10 Chuck key 11 Suspension bracket Always check that the power supply corresponds to the voltage on the rating plate. Your DEWALT tool is double insulated in accordance with EN 50144; therefore no earth wire is required. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. B) Percussion drill can be used in two operating modes: Never use a light socket. Never connect the live (L) or neutral (N) wires to the earth pin marked E or . For 115 V units with a power rating exceeding 1500 W, we recommend to fit a plug to BS4343 standard. If an extension cable is required, use an approved extension cable suitable for the power input of this tool (see technical data). Put the chuck key (10) into each hole in the side of the chuck and turn clockwise until tight. Fit the depth adjustment rod (7) through the hole in the side handle clamp. To select forward or reverse rotation, use the forward/reverse-switch (3) (see arrow on tool). Always wait until the motor has come to a complete standstill before changing the direction of rotation. [. . . ] If you need maintenance or service for your DEWALT tool, in the 12 months following purchase, it will be undertaken free of charge at an authorized DEWALT repair agent. Your DEWALT Power Tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning. If your DEWALT product becomes defective due to faulty materials or workmanship within 12 months from the date of purchase, we guarantee to replace all defective parts free of charge or, at our discretion, replace the unit free of charge provided that: · For the location of your nearest authorized DEWALT repair agent, please use the appropriate telephone number on the back of this manual. [. . . ]