User manual DEWALT DW966K-2

[. . . ] 13 Use appropriate tool The intended use is described in this instruction manual. Do not force small tools or attachments to do the job of a heavy-duty tool. The tool will do the job better and safer at the rate for which it was intended. The use of any accessory or attachment or performance of any operation with this tool, other than those recommended in this instruction manual may present a risk of personal injury. [. . . ] Always check that the battery pack power corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to that of your mains. Use an approved extension cable suitable for the power input of your charger (see technical data). Always switch OFF the tool before inserting or removing the battery pack. A) Charging the battery pack When charging the battery pack for the first time, or after prolonged storage, it will only accept an 80% charge. After several charge and discharge cycles, the battery pack will attain full capacity. If the mains is functioning but the battery pack does not charge, take your charger to an authorised DEWALT repair agent. whilst charging , the charger and the battery pack may become warm to touch. Do not charge the battery pack at ambient temperatures <4 °C or >40 °C. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. To charge the battery pack (6), insert it into the charger (8) as shown and plug in the charger. The battery pack can be removed at any time or left in the connected charger indefinitely. inserting and removing the battery pack · Insert the battery pack into the grip until it clicks in place. To remove the battery pack, press the two release buttons (7) simultaneously and pull the pack out of the grip. Without the protective cap in place, loose metal objects could short circuit the contacts, causing a fire hazard and damaging the battery pack. Take off the protective cap (10) before placing the battery pack (6) in the charger or tool. Place the protective cap over the contacts immediately after removing the battery pack from the charger or tool. [. . . ] Your DEWALT Power Tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning. Keep the ventilation slots clear and regularly clean the housing with a soft cloth. If you are not completely satisfied with the performance of your DEWALT tool, simply return it within 30 days, complete as purchased, to the point of purchase, for a full refund or exchange. [. . . ]