User manual DEWALT DWD115K

[. . . ] CAUTION: Used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in property damage. Vibration total values (triax vector sum) determined according to EN 60745: Vibration emission value ah Screwdriving without Impact ahD = m/s² 13 13 Uncertainty K = m/s² 1. The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. wARNING:Thedeclaredvibration emission level represents the main applications of the tool. [. . . ] useclampsorotherpracticalwayto secure and support the workpiece to a stable platform. Holding the work by hand or against your body is unstable and may lead to loss of control. In spite of the application of the relevant safety regulations and the implementation of safety devices, certain residual risks cannot be avoided. These are: ­ Impairment of hearing ­ Risk of personal injury due flying particles. The following pictograms are shown on the tool: Read instruction manual before use. DaTe cODe POsiTiOn Date Code, which also includes the year of manufacture, is printed into the housing surface. Always check that the power supply corresponds to the voltage on the rating plate. Your DeWALT charger is double insulated in accordance with EN 60745; therefore no earth wire is required. If the supply cord is damaged, it must be replaced by a specially prepared cord available through the DeWALT service organization. Shouldyourmainsplugneedreplacingandyou are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DeWALT repair agent or a qualified electrician. Cutoffthepluganddisposeofitsafely;aplug with bared copper conductors is dangerous if engaged in a live socket outlet. Beforereplacingthetopcoverofthemainsplug ensurethatthecablerestraint(3)isholdingthe outer sheath of the cable firmly and that the two leads are correctly fixed at the terminals crews. Checkfordamagetothetool, partsor accessories which may have occurred during transport. Use an approved extension cable suitable for the power input of your charger (see technical data). A variable speed trigger switch (a) permits speed control--the farther the trigger is depressed, the higher the speed of the drill. For continuous operation, press and hold the variable speed switch, move the lock-on button (b) up, then release the switch. NOTE: Use lower speeds for starting holes without a center punch, drilling in metal or plastics, driving screws or drilling ceramics. Higher speeds are better for drilling wood and composition boards and using abrasive and polishing accessories. The forward/reverse lever (c) is used for withdrawing bits from tight holes and removing screws. To reverse the motor, release the trigger switch FIRST and then push the lever to the right. to stop continuous operation , press the switch briefly and release it. [. . . ] To take advantage of this service please return your product to any authorised repair agent who will collect them on our behalf. You can check the location of your nearest authorised repair agent by contacting your local DeWALT office at the address indicated in this manual. Alternatively, a list of authorised DeWALT repair agents and full details of our after-sales service and contacts are available on the Internet at: www. If you are not completely satisfied with the performance of your DeWALT tool, simply return it within 30 days, complete as purchased, to the point of purchase, for a full refund or exchange. [. . . ]