User manual DOD FX90

[. . . ] Connect the OUTPUT of the FX90 to your amp (or to the input of another effects device). To eliminate the need for a 9-volt battery, attach the DOD PS200R to the AC adapter jack. The PS200R is a regulated supply that will not allow hum into the pedal. [. . . ] The PS200R is a regulated supply that will not allow hum into the pedal. FEATURES LED indicator shows status of effect and battery condition Active switching for noiseless operation Easy access battery compartment Adapter jack for AC operation Rugged die-cast metal case Three year limited warranty Rubber non-skid bottom CONTROLS MIX (DRY/TAPE) The MIX (DRY/TAPE) knob controls the mix level between the Dry and Effect level of the FX 96 Echo Fx. DELAY TIME: The DELAY TIME knob controls the delay time of the FX 96 Echo Fx. Turning the knob all of the way up produces up to approximatley 800 milliseconds of delay time. REGEN/REPEAT: The REGEN/REPEAT knob controls the amount of delay regeneration that is fed into the signal of the FX 96. By turning the knob all of the way up, this will produce more delay repeats. By turning down the REGEN/REPEAT control down, this will produce less repeats, TAPE QUALITY: The TAPE QUALITY knob controls the Low Pass Filter which is use to re-create analog tape quality variances of the past. The higher the TAPE QUALITY knob is turned up, the more "grainy" and Muddy the tape quality becomes. · Use of any AC adapter other than the DOD PS200R will void the warranty of this product. Should your FX90 require service, contact your DOD FX pedal dealer for return / repair information. DOD Warranty 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DOD warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DOD liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned through the original dealer, where all parts and labor will be covered up to a period of three years. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. DOD reserves the right to make changes in design or make additions to or improvements upon this product without incurring any obligation to install the same on products previously manufactured. DECLARATION OF CONFORMITY Manufacturer's Name: DOD Electronics Corporation Manufacturer's Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product Product Name: FX90 Product Options: All (requires a Class II power adapter that conforms to the requirements of EN 60065, EN 60742, or equivalent). [. . . ] The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. DOD reserves the right to make changes in design or make additions to or improvements upon this product without incurring any obligation to install the same on products previously manufactured. DECLARATION OF CONFORMITY Manufacturer's Name: DOD Electronics Corporation Manufacturer's Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product Product Name: FX90 Product Options: All (requires a Class II power adapter that conforms to the requirements of EN 60065, EN 60742, or equivalent). [. . . ]