User manual DOMENA EASYBOX NEO

[. . . ] € Use a mains supply which has an earth connection, for your own safety. € Never immerse the machine in water or other liquids, not even partially. € Take care to place the iron on its rest after each ironing operation. € any repair, contact an approved registered after-sales service centre, so that the repair will be in For accordance with the standards indicated in this instruction book. [. . . ] Start ironing the pieces requiring the lowest temperature, gradually going to those requiring the highest temperature. FUNCTIONS Steam settings Adjust the steam output to suit the type of material being ironed. The volume of steam increases gradually as you turn the control knob towards the maximum (+). At maximum setting, there is an initial burst of steam lasting for several seconds. To repeat this process, wait for a few seconds to avoid any risk of spotting. € If the iron is used intensively, steam may continue to be produced after the steam button has been released and water may appear on the iron holder. € You should turn the steam output dial to the middle setting: - when the unit is used for the first time - each time the water tanks has been refilled - each time the anti-scale cartridge has been changed. Because of the high steam output rate, there is no need to continuously press the steam button. Pressing the button briefly and frequently will enable you to control the quantity of steam, in order to obtain professional results and save time. The illuminated pilot light will confirm that this mode is operational. Each time the appliance is plugged in, press the “Mode Eco” button to use this function. When in “Mode Eco”, the variable steam control is not active (volume of steam cannot be adjusted). It is recommended that you use the ECO function when the garments are only slightly creased, have come out of a tumble dryer and when ever you think suitable. In this way you will be obtaining maximum economy in the use of water and electricity, up to 50% in electricity and 70% in water. The power on light flashes to indicate that the appliance is connected to the mains. The appliance is ready when the power on light is permanently on and when an audible signal sounds to indicate that the appliance is ready to supply steam. A CA NTI LC AU ST TO OP A CA NTI LC AU ST TO OP If you press on the steam button before the appliance is ready (on/off pilot light still flashing), an audible signal sounds to indicate that the steam generator is not ready to supply steam. When using your appliance for the first time, it may take some time until steam comes out. During ironing, the iron thermostat light regularly comes on and off to indicate if the iron is heating. Bügeltipp When the steam station has just been switched on, the steam output is low While waiting to get the selected steam output (most particularly the maximum steam output), start ironing the pieces of linen not requiring much steam. [. . . ] bringen Sie das Gerät zu einer zugelassenen Sammelstelle und geben Sie es in einen hierfür vorgesehenen Container , damit es recycelt werden kann. - Anti-scale cartridge needs to be replaced - The appliance is not ready. - Wait until the on/off pilot light is permanently on to use the appliance. - Check if any other pilot light - “AUTOSTOP” or “ANTI-CALC” - is lit. [. . . ]