User manual DOMENA PRIMALIS 100 DATASHEET

[. . . ] ­ Use a mains supply which has an earth connection, for your own safety. ­ Never immerse the machine in water or other liquids, not even partially. ­ Take care to place the iron on its rest after each ironing operation. ­ For any repair, contact an approved registered after-sales service centre, so that the repair will be in accordance with the standards indicated in this instruction book. [. . . ] You do not need to unplug the appliance, and can immediately re-commence ironing. To use steam please ensure that the thermostat dial is set within the 2 and 3 dot settings. According to model : Turn the variable steam control knob to the High position. ⷠWait about 3 minutes for the appliance to be ready, when both the iron and generator heating pilot lights go off. ⷠOnce the appliance is ready, press the steam trigger until steam comes out. Please note : Whilst you are ironing, the generator and iron heating pilot lights repeatedly go on and off. Adjust the flow control knob to suit the type of material being ironed. Gradually steam setting The volume of steam increases gradually as you turn the control knob towards the maximum. At maximum setting, there is an initial burst of steam lasting for several seconds. To repeat this process, wait for a few seconds to avoid any risk of spotting. Because of the high steam output rate, there is no need to continually press the steam button. Pressing the button briefly and frequently will enable you to control the quantity of steam, in order to obtain professional results. ⷠIf the iron is used intensively, steam may continue to be produced after the steam button has been released and water may appear on the iron holder. ⷠSelect maximum steam output when : the unit is used for the first time, the water tank has been refilled, the anti-scale cartridge has just been changed. To ensure regular steam output performance, your unit is equipped with a pump which is activated each time the steam trigger is pressed. : the appliance is used for the first time, the water tank is empty, the anti-scale cartridge has just been changed. Your iron can also be used vertically to steam clothing on hangers or curtains, etc. ⷠMove the iron from top to bottom, keeping the steam button pressed. ⷠIf you lie the machine on its side, water from the container may spill out. With tap water : Scaling is no longer a problem thanks to the antiscaling cartridge. Please remember, the grains will progressively change colour and they lose their efficiency. The cartridge needs replacing when the change in colour is on the top. [. . . ] Press the steam button - Go to your local approved service dealer - Put the dail to the settings ­ - Wait for the steam generator light to go out. - Press the steam button several times - Go to your local dealer - Press the steam button several times. - Fill the reservoir - Insert the reservoir and push it fully in - Go to your local approved service dealer - Insert an anti-scale cartridge into the reservoir - No danger It will stop when steam trigger has been pressed a few times. - The reservoir is empty - The reservoir is incorrectly inserted or has not been inserted. [. . . ]