User manual DOMENA XM-5 ECOFIBRES

[. . . ] € This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. € To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. € If an extension lead is absolutely necessary, a 10 amp cable should be used. [. . . ] Never fill the reservoir with hot water Never add products containing alcohol or essences (perfume, eau de Cologne, lavender essence…) to the water. REFILLING WITH WATER WHILST IRONING • You can refill the reservoir during ironing. You do not need to unplug the appliance, and can immediately re-commence ironing. Thermostat THERMOSTAT ADJUSTMENT • Adjust the thermostat of the iron according to the fabric. € To use steam please ensure that the thermostat dial is set within the 2 and 3 dot settings. TO OPERATE - HEATING PROCESS • Plug the power cable into an earthed socket. € According to model : Turn the variable steam control knob to the High position. If you press the steam trigger before the appliance is ready, an audible signal sounds to indicate that the generator is not ready to supply steam. € Once the appliance is ready, press the steam trigger until steam comes out. When you switch on the iron, it may take up to 90 seconds before you can call for steam. Please note : Whilst you are ironing, the generator and iron heating pilot lights repeatedly go on and off. STEAM FLOW RATE CONTROL KNOB Adjust the flow control knob to suit the type of material being ironed. Gradually steam setting The volume of steam increases gradually as you turn the control knob towards the maximum. At maximum setting, there is an initial burst of steam lasting for several seconds. To repeat this process, wait for a few seconds to avoid any risk of spotting. Please note • Because of the high steam output rate, there is no need to continually press the steam button. Pressing the button briefly and frequently will enable you to control the quantity of steam, in order to obtain professional results. € If the iron is used intensively, steam may continue to be produced after the steam button has been released and water may appear on the iron holder. [. . . ] Press the steam button - Go to your local approved service dealer - Put the dail to the settings GG – GGG - Wait for the steam generator light to go out. - Press the steam button several times - Go to your local dealer - Press the steam button several times. - Fill the reservoir - Insert the reservoir and push it fully in - Go to your local approved service dealer - Insert an anti-scale cartridge into the reservoir - No danger It will stop when steam trigger has been pressed a few times. [. . . ]