User manual DOMENA XPRESS 3

[. . . ] € To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. € If an extension cord is absolutely necessary, a 10-ampere cord should be used. Care should be taken to arrange the cord so that it cannot be pulled or tripped over. € Do not put your hand between the steaming board and the heating plate while ironing. [. . . ] To prevent accidental opening, your ironing press is locked for safety. Gently press the handle down and push the two locking buttons on the handle upwards. OPENING AND CLOSING THE PRESS The handle is used to open and close the heating plate. By lifting it with your hand, the pressure is released and the machine opens. By bringing the handle down, the machine closes and the pressing pressure increases until it automatically engages at maximum pressure. The handle also operates the automatic steam emission (see : Steam generation). MAXIMUM OPENING To obtain maximum opening of the press : open the press and continue to push the handle upwards. The steam board access is wide and the board can be used as a normal ironing board if desired. The maximum opening position allows large items to be pressed easily and can also used for folding the laundry. The heating plate returns automatically to its original position when lowering the handle. TYPES OF WATER You can use: Tap water, distilled water for irons, water produced by a condenser tumble drier provided that it is filtered (through a coffee filter). Do not use : Rain water, water from the fridge, water from any evaporating appliance. For appliance with EMC system, water supplied by your water softener if it is indicating the need for regenerating salts (incompatibility with the EMC system). Choosing your water You can use either tap water or distilled water for irons. Depending upon the calcium level contained in your tap water as well as upon your weekly ironing time (average time : 2/3 hours), it can be more economical to use distilled water for irons (not for car batteries). In this case, your cartridge should last up to 1 year (depending on the volume of your ironing and on the quantity of steam you ask for). Ventilate the strip for a few seconds and wait for the result approximately 1 minute. 2 or more mauve squares : we advise you to use distilled water for irons. 2 oder mehr lila gefärbte Felder: wir empfehlen Ihnen, handelsübliches destilliertes Wasser zu verwenden B TIPS Noise To ensure regular steam output performance, your unit is equipped with an injection pump which is activated each time you lower the handle in the half closed steam position. It is louder when: 1) the water tank is empty 2) the unit is used for the first time 3) the anti-calc cartridge has just been changed. Take hold the reservoir at both ends and pull it towards you until you see the fill hole (fill position) 7. Take hold of the reservoir in the middle and pull it completely out (position for changing the anti-scale cartridge and emptying). [. . . ] ANTI-SCALE CARTRIDGE The reference number to order anti-scale cartridges for the press SP4100/4200 with EMC is 413 045. The reference number to order anti-scale cartridges for the press SP4000 without EMC is 413 044. The anti-scale cartridges are available in blisterpack from your retailer. The natural disposal of these elements may trigger harmful effects on human health and the environment. [. . . ]