User manual DREMEL 670 MINISAW ATTACHMENT

[. . . ] Do not attempt to clean by inserting pointed objects through openings. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Some of these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia. [. . . ] Remove any adjusting key or wrench before switching the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. This enables better control of the power tool in unexpected situations. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. MINI SAW ATTACHMENT INSTALLATION It is extremely important to carefully read and follow the directions below to assemble the Mini Saw Attachment to your rotary tool and ensure the tool will function properly. (Figure D) Note: If the collet nut and collet are not removed from the motor shaft, the tool will not function properly. The correct power tool will do the job better and safer at the rate for which it was designed. Do not use the power tool if the switch does not switch it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. [. . . ] (Figure J) Support the panel or boards close to the cut, as shown in (Figure K). (a workpiece clamped with clamping devices or in a vice is held more securely than by hand). Do not support the work with the narrow sides as this is an unsteady arrangement. [. . . ]