User manual DREMEL 675 LAWN MOWER SHAPENING KIT

[. . . ] AVOID DANGEROUS ENVIRONMENTS Don't use power tools in damp or wet locations. Do not use the tool in the presence of flammable liquids or gases. DISCONNECT TOOLS FROM POWER SOURCE When not in use, before servicing, when changing blades, bits, cutters, etc. KEEP GUARDS IN PLACE In working order, and in proper adjustment and alignment. REMOVE ADJUSTING KEYS AND WRENCHES Form the habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. AVOID ACCIDENTAL STARTING Make sure the switch is in the "OFF" position before plugging in tool. [. . . ] Your tool also features table tilt dentents which automaticlly stops the table to the right or left every 15 degrees. A degree scale is also provided under the work table as a convenient reference for setting the approximate table angle for bevel cutting. When greater precision is required, make practice cuts and adjust the table as necessary for your requirements. Adjusting the hold down clamp The hold down clamp should always rest just above the workpiece to help prevent the workpiece from lifting from the table. Hold the drop foot, loosen the drop foot lock knob and lower by hand until it just rests above the workpiece surface, and securely tighten the drop foot lock knob. When cutting with the table angled, adjust drop foot so it's parallel to the table. To adjust, loosen screw with the allen wrench provided, turn foot to correct angle, tighten screw. Always make sure the blade does not contact either side of the drop foot, or the table opening. NOTE: When cutting at extreme angles, the drop foot should be lifted off the workpiece, as it will impede cutting. The drop foot may be disassembled when thick materials are cut at extreme angles. 4 DROP FOOT LOCK KNOB DROP FOOT MOUNTING SCREW TABLE TABLE LOCK KNOB DEGREE SCALE Aligning the Degree Scale Pointer The table is factory set to 0º. · The drop foot should always be lowered until it just rests on top of the workpiece. · You must feed the wood into the blade slowly because the teeth of the blade are very small and they can only remove wood when they are on the down stroke. · There is a learning curve for each person who wants to use this saw. During that period of time it is expected that some blades will break until you learn how to use the saw and receive the greatest benefit from the blades. 11. Basic Scroll Saw Operations Blades Your new Scroll Saw accepts 5 inch Pin-End blades or 5 inch Plain-End blades (See Accessories on page 18). To prevent personal injury always disconnect the plug from power source before changing blades or making adjustments. Release blade tension by lifting up the Quick Release Tension Lever (Fig. Open easy access door and loosen the blade clamping knob on the upper and lower blade holders. Remove blade from the upper and lower blade holders by pulling forward on blade and then lifting the blade through the access hole in the table. Install the blade by inserting one end of the blade through the access hole in the table and centering the blade in the blade slot in the upper and lower blade holders. To secure the blade securely tighten the clamping knob on the upper and lower holders. If desired, the allen wrench provided can assist in securely tightening the blade into the upper and lower blade holders (Fig. [. . . ] Reduce feed rate, see "BASIC SCROLL SAW OPERATION, " Page 11. Use narrow blades for cutting thin wood, wide blades for thicker wood. Any attempt to repair this motor may create a HAZARD unless repair is done by a qualified service technician. A plywood workbench will not be as good a work surface as the same size solid lumber. [. . . ]