User manual DSC PC580 V2.3

[. . . ] ·WARNING· This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manufacturer. The entire manual should be carefully read. Instruction Manual Software Version 2. 3 WARNING Please Read Carefully Note to Installers This warning contains vital information. As the only individual in contact with system users, it is your responsibility to bring each item in this warning to the attention of the users of this system. System Failures This system has been carefully designed to be as effective as possible. There are circumstances, however, involving fire, burglary, or other types of emergencies where it may not provide protection. [. . . ] The system cannot be armed unless the Ready light is ON (see "Arming the System" on page 4). Armed Light If the Armed light is ON, the system has been armed successfully. Trouble or System Light If the Trouble light is ON, see "Viewing Trouble Conditions" on page 11. 8 PC5508Z LED Keypad LCD5500Z Keypad PC5516(Z) LED Keypad PC5532(Z) LED Keypad The Liquid Crystal Display (LCD) displays prompts and system information on two 16 character lines. If "< >" appears, more information can be accessed by using the arrow (< >) keys. Press [>] to advance the display to next function or item of information. Press the keys on the number pad as prompted by the LCD display to view alarms or troubles, to arm and disarm the system and to bypass zones. To select a function press [D]. The PC5516, PC5516Z, PC5532 and PC5532Z Keypads are available for applications with more than 8 zones. The functions explained in this manual are the same for all three LED keypad types. Important Note: Test system weekly and have any system trouble conditions corrected by your alarm installer. 9 Programming codes from an LCD Keypad: Master Code Press the [D] key to enter the function list. Access Codes Enter Master Access Code Enter your current Master Code. The display will read. . . (*) to Edit <> "40P" represents the Master Code. Press the [D] key to indicate that you wish to User Code 40P program the Master Code. The Master Code must be four digits unless otherwise Enter New Code 1234 <> indicated by your installer. Once the new code is entered, the keypad will beep 3 times and the display will read. . . (*) to Edit <> Press [#] to exit the code programming function. User Code 40P Be sure to record your new Master Code on the "System Information" page in this booklet. NOTE: We recommend that the factory default Master Code [1234] not be used. Additional Access Codes To erase, add or change a user code, press [D] to enter the functions list. Use the arrow (< >) keys to scroll to the following message. . . Press (*) for <> Press [D]. Display will read. . . [*] to Edit <> Use the scroll keys (< >) to find the access code ­ indicated by "02P" to "32P" ­ User Code 01P you wish to add, change or delete. Access codes must be four digits Enter New Code 1234 <> unless otherwise indicated by your installer. Once the 4 digit code or [D] has been entered, the keypad sounder will beep 3 times and the display will read. . . [*] to Edit <> The "P" means the code has been programmed. Remember to record your new code(s) on the "System Information" page in this booklet. 10 Zone Bypassing The zone bypassing function is used when access is needed to part of the protected area while the system is armed. [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Re-orient the receiving antenna. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]