User manual DURKOPP 367 INSTRUCTIONS FOR FITTING FOR KIT 0367 595144

[. . . ] The user also has to assure that only authorized personnel work on the machine. The user is obliged to check the machine at least once per shift for apparent damages and to immediatly report any changes (including the performance in service), which impair the safety. The user company must ensure that the machine is only operated in perfect working order. [. . . ] Work on parts and systems under electric current is not permitted, except as specified in regulations DIN VDE 0105. Conversion or changes to the machine must be authorized by us and made only in adherence to all safety regulations. Commissioning of the sewing head is prohibited until such time as the entire sewing unit is found to comply with EC directives. This work must be carried out by appropriately trained technicians (see paragraph 8). It is absolutely necessary to respect the safety instructions marked by these signs. Fitting the pneumatic foot lift class 367 Fit and connect maintenance unit . The subclass 367-170010 can be retrofitted with the pneumatic foot lift. Should the pressure of your supply line be higher than 6 bar, it has to be reduced to 6 bar at the supply unit of the sewing machine!Before you start the installation: Please check whether all components of the retrofit kit are included in the scope of delivery. The complete mounting kit for the pneumatic foot lift with the order number 0367 595144 consists of the following components: 3 m Hose 1 2 1 1 1 1 1 1 1 1 2 1 1 1 Connection WI-N Screw connection GD-E Screw connection WI-E Cylinder Bars Fastening clip Maintenance unit Pressure line Coupling box Coupling plug (at the pressure line) Ideal clip (1x at the pressure line) Hose nozzle Allen screw Pneumatic device plan Switch off the main switch and pull out the mains plug before you start to install the pneumatic foot lift. Remove the locking washer 3from the right end of the slide bar 2 and the screw 1 from the left end of the slide bar 2. Run the hose 6 through the fixture 5 at the rear panel of the machine. The piston must show to the right and the throttling screw 7 must show down. If you turn the throttling screw 7 counter-clockwise, the piston is moving more quickly. If you turn the throttling screw 7 in clockwise direction, the piston is moving more slowly. Put the locking washer 3 on the right of the cylinder 4 again and screw in screw 1 on the left again. Run the hose outside through the cut-out 9 down on the right of the sewing machine. In order to measure the length of the hose 6, hold the fastening clip 10 close to the drill-hole down on the right of the sewing machine. [. . . ] Connect the screw connection GD-E 5 and the screw connection WI-E 9 at the maintenance unit with the remaining hose. Then push the pressure line 16 on the hose nozzle 10 at the maintenance unit 13. Secure the pressure line on the connection piece 10 by the Ideal clip 15. [. . . ]