User manual DYSON DC02

[. . . ] Call or fax the Helpline for orders. IMPORTANT: Use only genuine Dyson filters, which have been tested and approved for this cleaner. The Dyson DC02 has a built-in thermal cut-out to protect your vacuum NOTE cleaner in the event of a restriction to the airflow. Having established that there are no blockages and that the filters have been replaced within the stated time, leave your vacuum cleaner detailed in for operating and then try using again. Having established that there are no blockages and that the filters have been replaced within the stated time, leave your vacuum cleaner unplugged for 60 minutes and then try using it again. [. . . ] The appliance must only be used as rated, it should be fitted with an ASTA approved fuse to BS1362. European conformity information A sample of this product has been tested and found to be in conformity with the following European Directives: 73/23/EEC Low voltage (safety) Directive, 93/68/EEC CE Marketing Directive and 89/336/EEC EMC Directive. For your convenience this appliance is supplied with a plug which is fitted with a 13amp fuse of the appropriate rating. Never put the plug into the socket outlet without the fuse cover fitted. If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed/safely disposed of. Warning: Under no circumstances should the severed plug be inserted into a 13A socket, serious danger of electric shock would result from the exposed wires. The mains lead can then be shortened to the minimum required length, suitably prepared and the correct style of plug to suit your household wiring system should be fitted. Unwanted products and the environment Should you find that your product needs replacing one day, or is of no further use to you, think of protecting the environment. Dyson will accept your old products and recycle them in an environmentally friendly way. IMPORTANT The wires in the mains lead are coloured in accordance with the following codes. 2. Brown ­ Live Blue ­ Neutral As the colours of the wires in the mains lead may not correspond with the colours or markings identifying the terminals in your plug, proceed as follows: The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black. The wire that is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red. Neither wire should be connected to the earth terminal of a three pin plug which is marked with the letter E or or coloured Green or Green and Yellow. Always ensure that the cable clamp is fitted and that it clamps the cable outer and NOT the coloured wires. If the supply cord of the appliance is damaged, disconnect the appliance from the socket outlet immediately. or their appointed agent as special purpose tools and service techniques are required. 9. 3. 10. [. . . ] Remove floor tool from 4 wand and check for blockage. 6 Wipe shroud holes free of all dust/debris. 7 Do not use strong detergents and ensure clear bin is fully dry before replacing in machine. Note: The yellow bin inner should not be removed from the bin when it is cleaned. Ensure release catch `clicks' into position before using the vacuum cleaner or lifting the machine by the carrying handle. Cord rewind Press right switch for cord rewind. [. . . ]