User manual DYSON DC40

[. . . ] Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they or their vapors may be present. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts. Do not point the hose, wand or tools at your eyes or ears or put them in your mouth. [. . . ] CLEANING THE CLEAR BIN • • Remove the cyclone and clear bin (instructions above). To separate the cyclone unit from the clear bin press the red button to open the clear bin base. Press the silver button and separate the cyclone unit from the clear bin. Do not use detergents, polishes or air fresheners to clean the clear bin. Do not immerse the whole cyclone unit in water or pour water into the cyclones. Clean the cyclone shroud with a dry cloth or dry brush to remove lint and dust. To refit: – f it the cyclone shroud into the clear bin so that the silver button clicks and  engages – close the clear bin base so it clicks into place – push the cyclone and clear bin unit into the main body of the appliance;  it will click into place – ensure the cyclone and clear bin unit is secure. CARPETS OR HARD FLOORS • • • The brush bar will always default to ‘ON’ (spinning) each time you switch the appliance ‘ON’ and recline it for cleaning. For delicate rugs and hard floors): – switch the appliance ‘ON’ – recline the appliance – press the brush bar ‘ON/OFF’ button – the brush bar will stop spinning. Before vacuuming your flooring, rugs and carpets, check the manufacturer’s recommended cleaning instructions. If this happens, we recommend vacuuming in ‘hard floor’ mode and consulting with the flooring manufacturer. • • • • • • • • • • • WASHING YOUR FILTERS • • • • • • • • • Your appliance has two washable filters , located as shown. Check and wash the filters regularly according to instructions to maintain performance. Switch ‘OFF’ and unplug before checking or removing the filters. Do not put the filters in a dishwasher, washing machine, tumble dryer, oven, microwave or near an open flame. To remove filter A see the ‘Wash filters’ section in this Dyson Operating Manual. After washing lay filter A on its side and leave at least 24 hours to dry completely before refitting. To remove filter B: – turn the central locking dial on the outer cover of the ball counter-clockwise  until the cover is released – lift off the cover – turn the filter one-quarter counter-clockwise to release. Filter B should be rinsed and tapped out until the water runs clean, then tapped out again to ensure all excess water is removed. To refit filter B: – refit the filter on to the ball – secure the filter by turning it one-quarter turn clockwise. When refitting the outer cover of the ball, keep turning the central locking dial clockwise. Com/DC40filterwash LOOKING AFTER YOUR DYSON APPLIANCE • • • • • Do not carry out any maintenance or repair work other than that shown in this Dyson Operating Manual, or advised by the Dyson Helpline. [. . . ] If your Dyson appliance needs service, call the Dyson Helpline so we can discuss the available options. If your Dyson appliance is under warranty, and it is a covered repair, it will be repaired at no cost. DISPOSAL INFORMATION Dyson products are made from high grade recyclable materials and so should not be treated as household waste. To protect the environment please dispose of this product responsibly and recycle where possible. [. . . ]