User manual DYSON V8 ABSOLUTE

[. . . ] OPERATING MANUAL GUIDE D’UTILISATION ASSEMBLY ASSEMBLAGE clik clik 5 hrs WASH FILTERS Wash filters with cold water at least every month. (25 minutes avec la brosse à moteur) 7 minutes SV10 IMPORTANT SAFETY INSTRUCTIONS BEFORE USING THIS APPLIANCE READ ALL INSTRUCTIONS AND CAUTIONARY MARKINGS IN THIS MANUAL AND ON THE APPLIANCE When using an electrical appliance, basic precautions should always be followed, including the following: WARNING 1. These warnings apply to the appliance, and also where applicable, to all tools, accessories, chargers or mains adaptors. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY: This Dyson appliance is not intended for use by persons (including children) with reduced physical, sensory or reasoning capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] If this happens, we recommend vacuuming without the motorized floor tool and consulting with your flooring manufacturer. Before vacuuming highly polished floors, such as wood or linoleum, first check that the underside of the floor tool and its brushes are free from foreign objects that could cause marking. € 1 • • • • 2 3 LOOKING AFTER YOUR DYSON APPLIANCE Do not carry out any maintenance or repair work other than that shown in this Dyson Operating Manual, or advised by the Dyson Helpline. Do not use any lubricants, cleaning agents, polishes or air fresheners on any part of the appliance. € • • • • • WASHING FILTER B To remove the filter, twist anti clockwise to the open position and pull away from the appliance. Wash the inside of the filter under cold running water, rotating the filter to ensure all pleats are covered. Gently tap the filter against the side of the sink several times to remove any debris. Place the filter upright, with the top of the filter facing upwards, and leave to dry completely for a minimum of 24 hours. To refit, return the filter to the open position and twist clockwise until it clicks into place. 1 VACUUMING • • • • Do not use without the clear bin and filters in place. Fine dirt such as flour should only be vacuumed in very small amounts. Do not use the appliance to pick up sharp hard objects, small toys, pins, paper clips, etc. When vacuuming, certain carpets may generate small static charges in the clear bin or wand. These are harmless and are not associated with the mains electricity supply. To minimize any effect from this, do not put your hand or insert any object into the clear bin unless you have first emptied it. Do not press down on the nozzle with excessive force when using the appliance as this may cause damage. On waxed floors the movement of the cleaner head may create an uneven lustre. If this happens, wipe with a damp cloth, polish the area with wax, and wait for it to dry. 2 4 5 LOOKING FOR BLOCKAGES • • • • The motor will pulse when there is a blockage. Please follow the instructions below to locate the blockage: Ensure the appliance is disconnected from the charger before looking for blockages. Do not operate while checking for blockages as doing so could result in personal injury. To check for blockages in the main body of the appliance, remove the clear bin and cyclone as per the instructions in the cleaning the clear bin section and remove the blockage. [. . . ] Ca Before service can take place, the terms of the warranty require that you contact the Dyson Helpline with your model name/number, serial number, date and place of purchase. Please keep your purchase receipt in a safe place to ensure you have this information. All work will be coordinated by Dyson Canada Limited or its authorized agents. Service under this warranty will not extend the period of this warranty. [. . . ]