User manual EARLEX SPRAY STATION 3500_

[. . . ] The powerful motor can spray a wide range of solutions with or without dilution. However, there will always be some which will not be suitable for the Spray Gun. Good quality paint contains a high percentage of solids which make the dilution easier. The users must keep in mind that low temperatures make the paint thicker, that's why we recommend spraying with the Spray Gun at a 15°C minimum temperature. [. . . ] Very important: when spraying for the first time, we recommend that you always leave the motor unit to run for 1 to 2 minutes before applying the product. Do not forget that the Paint Flow Adjuster controls the quantity of paint sprayed (Fig. The most commonly used technique for painting a large surface is the `crisscross' technique, i. You apply the product in a horizontal strips and then cross over these strips by applying the product in a vertical strips (Fig. 1) To achieve a horizontal strip adjust the Spray Direction Plate to the vertical position then pull the Trigger and move your arm across to the right. Round Spray Round for small and precise jobs 3) Next, to achieve a vertical strip adjust the Spray Direction Plate to the horizontal position then pull the Trigger and move your arm up and down over the horizontal strips you just have sprayed. 2) When you get to the end of the line, release the Trigger for a moment and then apply the product in the opposite direction just beneath the line you have sprayed. Through gradual movement of the Spray Direction Plate (4) between Horizontal, Vertical and Round spray pattern you can vary the width of the pattern (Fig. 3) HINT: To obtain the best results always keep your Spray Gun level and at an equal distance from the object you are spraying, ideally 25-30cm (10"-12") (Fig. HINT: HVLP technology produces warm air through the Air Cap allowing the paint to dry quicker which can enhance the final effect. HINT: For ceilings and floors make sure the Pick-up Tube is properly oriented towards the handle of the Spray Gun. Water based paint Oiled based paint HINT: When done immediately the cleaning operation can take you less than 5 minutes. If taking a break, leave the Spray Gun in a plastic bag to prevent the paint from drying. Pour any leftover paint into its container so that it can be used for the future. Pour a quantity of the respective thinner into container, shake the Spray Gun lightly, reassemble the Spray Gun, then spray this liquid though the Spray Gun. Repeat this until the thinner being sprayed is coming through with no traces of paint. It is recommended that you push the Trigger forward to help release the Fluid Tip (5). using the Needle and Fluid Tip Tool - pincer end A (1) remove the Fluid Tip (5). Insert the Needle and Fluid Tip end B (1) into the inner tube and unscrew the Needle anticlockwise, then pull to release the Needle. Place all of these items into a container and clean, then using a brush and the respective thinners. [. . . ] Please do not dispose of tools with your household waste collected by the council. It is your responsibility to dispose of this type of waste by handing it over to a special designated collection point for recovery and recycling. GUARANTEE and HELPLINE This product is guaranteed for a period of 24 months against faulty manufacture or materials. For further information or any user advice, please phone our helpline between 9am to 12pm and 2pm to 5pm Mondays to Fridays (excluding Bank Holidays), or visit our website www. [. . . ]