User manual ELECTROLUX ESI64602XR

[. . . ] Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. The first time you use the appliance, make sure that there is no leakage. [. . . ] Start the shortest programme with a rinsing phase, without detergent and without dishes. Make sure that the set level of the water softener agrees with the water hardness in your area. Contact your local water authority to know the water hardness in your area. If you use the combi detergent tablets, activate the multitab function. Be sure that these tablets are applicable to the water hardness in your area. Hard water contains a high quantity of minerals that can cause damage to the appliance and bad washing results. The dishwasher salt keeps the water softener clean and in good conditions. It makes sure that the water softener uses the correct quantity of dishwasher salt and water. Press and hold Delay and Start at the same time until the indicators (A), (B) and (C) flash. The display shows the setting of the Press Program again and again to change the setting. The rinse aid, during the last rinsing phase, helps to dry the dishes without streaks and stains. Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 (highest quantity). If the salt indicator is on, fill the salt If the rinse aid indicator is on, fill the For the type of load and soil. lOADING THE BASKETS Refer to the supplied leaflet with examples of the load of the baskets. Do not put in the appliance items made of wood, horn, aluminium, pewter and copper. Do not put in the appliance items that can absorb water (sponges, household cloths). Make sure that the spray arms can move freely before you start a programme. If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. Detergent tablets do not fully dissolve with short programmes and detergent residues can stay on the dishes. The appliance is in setting mode when, after the activation: · The display shows two horizontal status bars. [. . . ] Make sure that the set level of the water softener agrees with the water hardness in your area. Make sure that you add the correct quantity of detergent in the dispenser before you start a programme. The released quantity of Increase the released quantirinse aid was not sufficient . The quality of the detergent Try a different brand of de- Can be the cause. [. . . ]