User manual ELEKTRO HELIOS FB 325

[. . . ] paint shops. If the device should come into contact with liquid: Switch the handset off and remove the batteries immediately. Pat all parts dry, then with the battery compartment open and the keypad facing down place the handset in a dry, warm place for at least 72 hours (not in a microwave, oven etc. ). When it has fully dried out, you will normally be able to use it again. If you give your Gigaset to someone else, make sure you also give them the user guide. Please remove faulty base stations from use or have them repaired by Gigaset service, as they could interfere with other wireless services. [. . . ] The polarity is indicated in/on the battery compartment. ¤ Slide the battery cover from bottom up onto the casing until it clicks into place. ¤ If you need to open the battery cover, for instance to replace the batteries, press the ribbing at the top of the battery cover and slide it downward. Placing the handset in the base/charger Place the handset in the base/charger with its display facing forward. Each handset of your package is registered with the base at the factory. If you wish to use your handset with a different base or use further handsets with your base, you have to register the handset manpage 11). ually ( ¤ ¢ To charge the batteries, leave the handset in the base/charger. Please note Only place the handset in the designated base/charger. 7 Initial charging and discharging of the batteries The correct charge level can only be displayed if the batteries are first fully charged and discharged. 18 h ¤ Place the handset in the base station or charging cradle for 18 hours. ¤ Then remove the handset from the base station or charging cradle and do not replace it until the batteries are completely discharged. Please note After the first battery charge and discharge you may replace your handset in the base station or charging cradle after every call. Always repeat the charging and discharging procedure if you remove the batteries from the handset and reinsert them. The batteries may warm up during charging. After a while, the charge capacity of the batteries will decrease for technical reasons. Warning Please ensure that the handset is in the charging cradle if you are absent for a long time (e. g. Else the batteries could be damaged. Charge status of the batteries The charge status is indicated by the top right display icon. After the initial charging procedure a complete charging to full capacity takes at least 18 hours. The calls list is displayed as follows: CallsList 01+02 Number of new entries + number of old, read entries ¢ OK Last number redial list This list contains the 10 last dialled numbers. Dialling from the last number redial list c (press briefly) ¢ u (select entry) ¢ c 11 Open the calls list f ¢ CallsList 01+02 ¢ OK The last incoming call is displayed. If necessary, use u to select another entry. Registering handsets You can register up to four handsets on your base station (Gigaset A39H/A49H recommended). Please note Each additional handset must be registered on the base station in order for it to work properly! u (select entry) ¢ MENU The following functions can be selected with u: Delete Entry Copy to Dir. If the first internal participant presses the end call key a, the handset that has "listened in" remains connected to the external participant. ~ (1. . . 4, enter internal number of the handset), the handset is called or INT star key P , all handsets are called. To end the call, press a. INT ¢ ¢ Internal consultation call/ connecting a call You are in conversation with an external participant. Before the internal participant has answered, press the end call key a; the call is diverted to the participant who answers the call. Press the end call key a; the call is diverted, or press the " display key; you are reconnected to the external participant. Setting the alarm clock Activating/deactivating the alarm clock MENU Alarm Clock OK Activation OK Off or On OK ¢ ¢¢ ¢¢ ¢ When activated: ¢ Set the wake-up time ¢ OK When the alarm clock rings, press any key to switch it off for 24 hours. If the alarm clock is set, the wake-up icon l will appear on the screen and the wake-up time will be displayed instead of the date. Listening in to an external call You are conducting an external call. An internal participant can listen in on this call and take part in the conversation (conference). Precondition: The Listening in function must be activated. Setting the wake-up time MENU time ¢ Alarm Clock ¢ OK ¢ Wake-up ¢ OK Enter the wake-up time in hours and minutes, then press OK. 13 Phone settings For details on how to make audio settings, page 15. see Menu tree For details on how to set the system PIN on the base station, see the Menu tree page 16. ¢ ¢ Hardware reset Disconnect the power cord from the base station. [. . . ] replaced 3-4 assignment of by a new telephone leads/ cord with EURO CTR37. Error tone The sysReset the system PIN to sounds after tem PIN the default 0000 page 13. switched on. ¢ ¢ ¢ 15 Menu tree Your phone has an extensive range of features. To select a function while the phone is in idle status, press MENU (open menu), use Alarm Clock Activation Wake-up time Activating/deactivating the alarm clock Input format: HHMM the t and v keys to scroll to the function you require and press OK to confirm. [. . . ]