User manual EMTEC EKCOH420

[. . . ] The 2 in 1 Universal Remote Control contains a library of codes that are pre-programmed into the remote control. This library covers nearly all the audio video products on the market today. Insert CR2032 battery, verify that they are placed correctly with the + on the battery in the same position as marked inside the battery compartment. 3) Functions of the keys 2 [1] LED indicator: The indicator light flashes when the remote is operating or lights continuously while you are programming the remote. [. . . ] If you entered a wrong code the LED blinks for 3 seconds and then goes off. Point the remote in the direction of your TV and press the POWER button (3). If certain functions are not responding this indicates that the entered code is not the correct one. In that case repeat the above procedure with the next corresponding code of your brand. Repeat this procedure from step 1 for the other equipment you want to control (TV, VCR, DVD, SAT) 5) Manual code search If your equipment (TV, SAT etc. ) to the AUX keys you need first to enter any 4 digit code for the kind of appliance you wish to control (found in the code book), i. : If you want to program a SAT under the AUX key, enter any SAT code found in the code book and then follow the steps below: 1, Make sure your equipment is switched on. Press the mode key (9) that matches the equipment you want to control (for example TV). If you step past the correct code use PROG - (6) to go back to the right code. When the equipment you want to control reacts press -/-- (13) to confirm the code. Note: If your equipment doesn’t have PROG +, you can use PLAY (VCR or DVD) (5) or POWER (3) key. If that was 0030, the search starts at 0031 until the last possible code and then goes from 0000 to 0029. Note: if certain functions of your equipment can’t be controlled you have to find a different code for your brand. 6) Automatic code search When searching an unknown code, you can step through the library automatically (AutoSearch). When your equipment responds, you can stop the searching process and store the code you found. ) to the AUX key, you need first to enter any 4 digit code for the kind of appliance you wish to control (found in the code book, i. : If you want to program a SAT under the AUX key, enter any SAT code found in the code book and then follow the steps below: 1. Press the mode button (3) that matches the equipment you wish to control. After a few seconds the remote starts stepping through the code library (fast search, 1 code per second). When the device responds, you can press PROG+ (6) to switch to slow search (1 code per 3 seconds). You can step back by pressing PROG- (6) (you can step forward by pressing PROG+ (6) in case you went too far back). As soon as the device responds again, press the -/-- key (13) to store the code you found. [. . . ] If the remote loses codes within a few days/weeks the problem can be solved by using 2 new batteries from the same brand. If the LED is lit permanently, in general it will be necessary to replace the batteries. Important: The 2 in 1 Universal Remote Control must be used only in the way described in this instruction manual and may not be used for a purpose not intended. € Apăsaţi şi eliberaţi tasta Shift, după care apăsaţi tasta funcţională pe care o doriţi. [. . . ]