User manual EMTEC HDD PHOTO CUBE

[. . . ] Please consult the reference of operating in USB mode in the latter part of this instruction. P5 -Left Side : CF/MD Card Slot -If you want to copy the data within CF/MD flash card, please open the card slot cover on left side and insert the flash card with face upward carefully. Note: -Please push the card slot cover to the direction of arrow on it carefully. To avoid breakage of the cover, please push it without violence. -Right Side : SD/MMC/MS Card Slot -If you want to copy the data within SD/MMC/MS card, please open the card slot cover on right side and insert the flash card under the guidance on the faceplate carefully. [. . . ] 2) Double click " MY COMPUTER" and enter into MY COMPUTER folder, you will find three removable disk icons and two local disk icons, which indicating three kinds of flash cards and two partitions of built-in harddisk. Now you can access your files on built-in harddisk and flash cards through your computer. 3) To avoid the damage to the unit or data loss, please follow the procedure listed below to disconnect the unit from the USB port on your computer. ·Double click "Safely Remove Hardware" icon on the task bar. ·From the "Safely Remove Hardware" window, select "USB Mass Storage Device" and click "Stop". When the "Safe to Remove Hardware" window is displayed, you can turn off the unit and remove it from the USB cable or remove it without turning off. Note: -Do not unplug the USB cable or remove the flash card from the unit when the computer is detecting for the hardware or copy is in process. Otherwise, the computer and the unit may be hanging as well as the data within the harddisk may be damaged and lost. -In USB mode, the unit will be charged by the aid of USB cable when it is off. However, it will only be supported with electronic power but not be charged through USB cable when it is on. To avoid lack of power when the unit is used in USB mode, please connect the DC power adapter during your usage. P10 6. Partition the Harddisk ­ supposed under WINDOWS 2000/XP system : 1) Click "START" menu on the task bar and select "SETTINGS" / "CONTROL PANEL" / "ADMINISTRATIVE TOOLS" / "COMPUTER MANAGEMENT". 2) Click on "DISK MANAGEMENT", and disk drives currently connected to the system will be listed on the right side. 3) To delete an existing partition, right click on the drive and select "DELETE PARTITION". 4) To create a new partition, right click on the drive and select "NEW PARTITION". 5) Select "PRIMARY PARTITION" or other types as you want and click "NEXT". 6) Because you can only create FAT32 partition, set the partition size to 32000MB or less and click "NEXT' ("Disk Management" can not create FAT32 partitions larger than this). (If FAT32 is not listed as an option, go back to step6 and reduce the size to 32000MB or less. ) 9) Click "NEXT" to confirm settings. 10) Click "FINISH" to close the wizard and start the partition and format process. Note: -Only FAT32 is supported for harddisk formatting and maximum 4 partitions. -To avoid the unit being shut down when it is working with not enough power, please connect DC power adapter to it during the process of partition. P11 7. 4) All copied files will be saved in the respective folders in the built-in harddisk, namely corresponding to the card, such as CF, MS, SD and MMC. [. . . ] 8) Do not leave the unit in a location subject to water or a humid environment. 9) Use DC power adapter when the unit is connected to the computer on work. 10) Back up and clean up the data within the harddisk at time to keep enough memory for copy. P13 12. Troubleshooting : If you experience a problem with this unit, please consult the following instruction firstly. [. . . ]