User manual EMTEC UNIVERSAL REMOTE CONTROL H360

[. . . ] Technical manipulations of the product or any changes to the product are forbidden, because of security and approval issues. Please take care to set up the device correctly ­ consult your user guide. avoid the following: Strong mechanical wear and tear High temperature Strong vibrations High Humidity Please also respect the additional notes in the various user guide chapters. For questions not covered from the user guide please contact our technical hotline or another specialist. [. . . ] If certain functions are not responding this indicates that the entered code is not the correct one. In that case repeat the above procedure with the next corresponding code of your brand. Repeat this procedure from step "a" for the other equipment you want to control (TV, VCR, DVD, SAT, etc. TV/VCR, TV/DVD, DVD/VCR, etc) will require you to set up two different Mode keys to control both parts of the Combo device. For example, if you have a TV/DVD Combo, you might need to set up one code under the TV key to control the TV part AND a separate code (under any other Mode key) to control the DVD part. For example, if your Combo device is a DVD/VCR then its original remote may have separate DVD and VCR keys for selection of the Combo part you would control. The equivalent key functions can be found on your remote by using the Mode and Setup keys. Assuming your Combo device is a DVD/VCR and its code is programmed under DVD Mode: press and hold the DVD Mode key for more than one second to send the DVD key command, Quickly press and release the S key followed by pressing and releasing the DVD Mode key to send the VCR key command. Volume/Mute Control and Punch-Through Feature:- This remote allows you to select which Mode controls your Volume/Mute keys. If the programmed "Visual" code has no Volume/Mute operation of its own then those keys will punch-through control to the TV Mode device without needing to change to TV Mode. Setting Volume/Mute Control and Punch-Through - Any Mode chosen for Volume/Mute control MUST have its own Volume/Mute function either in the programmed code or learned otherwise the Volume/Mute keys will do nothing. TV :- This routine will set all Modes to punchthrough to any one chosen Mode for Volume/Mute key control without the needing to change to that Mode. "Please Wait" will be displayed briefly followed by "Success" and the remote will exit Setup and return to normal operation. All Modes will now punch-through to your chosen Mode for Volume/Mute control. If the chosen Mode has no Volume/Mute commands of its own, "Volume Control Error" will be shown in the display and the remote will exit Setup routine and return to normal operation. This routine will set any Mode to use only its own Volume/Mute control i. Note: before using this routine, check that the chosen Mode has its own Volume/Mute functions, either in the code or by learning, otherwise the Volume/Mute keys will do nothing. "Please Wait" will be displayed briefly followed by "Success" and the remote will exit Setup routine and return to normal operation. This routine will reset Volume/Mute control back to its Factory default settings. Using the Up/Down keys, navigate to "Vol/Mute Control Reset". "Please Wait" will be displayed briefly followed by "Success" and the remote will exit Setup routine and return to normal operation. Use the Up/Down keys to set the minutes then press and release the OK key. [. . . ] Using the Up/Down keys, navigate to "Clear All Learn Modes". The MACRO key, in conjunction with digits 1, 2 and 3, lets you to program and store up to 3 sequences of key-presses of your choice. One press of the respective Macro digit key results in that sequence of keypresses (IR commands) being sent. Any sequence of key-presses that you regularly perform can be reduced to two keypresses (MACRO key followed by digit 1, 2 or 3 key). [. . . ]