User manual EMTEC USB STICK S510

[. . . ] Further, this company reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation to notify any person of such revision or changes. All brand and product names mentioned in this manual are trademarks and/or registered trademarks of their respective holders. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] (ad hoc) network; wireless access Infrastructure ­ This operation mode requires the presence of points are not used. Ad Hoc ­ Connect to another wireless adapter in the Wireless LAN network without through an Access Point or Router. Profile Name Define a recognizable profile name for you to identify the different networks. The SSID (up to 32 printable ASCII characters) is the unique name identified in a WLAN. You may specify a SSID for the adapter and then only the device with the same SSID can interconnect to the adapter. 21 Network Name (SSID) Parameter Channel Description This setting is only available for Ad Hoc mode. The channel setting should be the same with the network you are connecting to. This setting has to be consistent with the wireless networks that the adapter intends to connect. Note that in Windows Vista, the adapter only supports Open System, Shared Key, WPA-PSK and WPA2-PSK security methods. Open System ­ No authentication is needed among the wireless network. Shared Key ­ Only wireless stations using a shared key (WEP Key identified) are allowed to connecting each other. LEAP ­ LEAP is a pre-EAP, Cisco-proprietary protocol, with many of the features of EAP protocols. Cisco controls the ability of other vendors to implement this protocol, so it should be selected for use only when limited vendor choice for client, access-point, and server products is not a concern. When you have set up LEAP authentication, you have to enter the user name and password of your computer. PEAP & TTLS ­ PEAP and TTLS are similar and easier than TLS in that they specify a stand-alone authentication protocol be used within an encrypted tunnel. TTLS supports any protocol within its tunnel, including CHAP, MSCHAP, MSCHAPv2 and PAP. PEAP specifies that an EAP-compliant authentication protocol must be used; this adaptor supports MD5, TLS, GTC (Generic Token Card) and MSCHAPv2. The client certificate is optional required for the authentication. Tunnel Includes MD5, GTC, TLS, CHAP, MSCHAP, MSCHAP-v2 and PAP. The certificate username in the RADIUS server. Username Identity User's identity in the RADIUS server. Password User's password in the RADIUS server. Certificate The certificate for RADIUS server for certification. 24 3. 5 Advanced The "Advanced" option enables you to configure more advanced settings, for example: Power Save, Turbo Mode, Wireless Mode and etc. Parameter Power Save Description None ­ The adapter will always set in active mode. Min ­ Enable the adapter in the power saving mode when it is idle, but some components of the adapter are still alive. In this mode, the power consumption is larger than "Max" mode. [. . . ] What does IEEE 802. 11 feature support The product supports the following IEEE 802. 11 functions: CSMA/CA plus Acknowledge Protocol Multi-Channel Roaming Automatic Rate Selection RTS/CTS Feature Fragmentation Power Management 4. What is Ad-hoc An Ad-hoc integrated wireless LAN is a group of computers, each has a Wireless LAN adapter, Connected as an independent wireless LAN. Ad hoc wireless LAN is applicable at a departmental scale for a branch or SOHO operation. 5. What is Infrastructure An integrated wireless and wireless and wired LAN is called an Infrastructure configuration. [. . . ]