User manual EOTECH HOLO GRAPHIC SIGHT

[. . . ] 1 User Manual BATTERIES Two (2) commonly available Type N alkaline 1. 5 V batteries power your HOLOgraphic Archery Sight. The HOLOgraphic Archery Sight is designed to maintain constant brightness at a particular setting as the batteries drain down. The reticle brightness will not fade gradually as the batteries run down but rather shut down abruptly. Another indication of low batteries is the reticle pattern blinking off and on during recoil. [. . . ] After the battery compartment is removed, slide the batteries out and replace them with a fresh set. The labels on the bottom of battery compartment show the correct battery orientation. To re-install the battery compartment, point the sight towards the ground and slide battery compartmant onto base. Make sure there is enough clearance between the contact and the batteries to avoid bending the contacts. Hold the battery compartment down firmly against the base and close the locking cam. Before you push down on cam lever, make sure the battery compartment sits all the way down and parallel to the base. Verify correct battery installation immediately by turning on the sight and checking if the holographic reticle appears. If the batteries are left in the sight backwards, they will be drained of their power. 2 MOUNTING The Holographic Archery Sight Requires the use of a mounting adaptor that has it's own elevation and course windage adjustments. Please read the instruction that were sent with your mounting adaptor for correct installation and zeroing. SIGHTING AND ZEROING It is important to have your anchor point set-up correctly before beginning to adjust your windage and elevation. Refer to your mount manual for correct anchor point alignment and elevation/windage zeroing. FINE WINDAGE ADJUSTMENT Your HOLOgraphic Archery Sight features a click mechanism for windage adjustments. The windage adjustment is located on the Right-hand side of the sight (Figure 1). The knob towards the rear is a housing plug and should not be tampered with. This adjustment mechanism is grooved with a slotted screw head and requires the use of a screwdriver, or coin to turn. Each click will change the arrow's point of impact 1/2 Minute of Angle (MOA), which translates to 1/4 inch at 50 yards, 1/8 inch at 25 yards. Also, one full rotation of the knob will change your point of impact 10 MOA. To move the point of impact RIGHT, turn the adjustment screw clockwise; to move the point of impact LEFT, turn the adjustment screw counterclockwise . Caution: DO NOT use the micro windage adjustments for greater than 4 inch adjustments in either direction at 20 yards. Refer to your mount user manual for zeroing sight within 4 inches @ 20 yards (Coarse Adjustment). The windage adjustment has been intially set at the factory near the midpoint of it's adjustment range and should be close to being at zero with a properly installed mounting rail. Please do not turn the adjustment before mounting the sight on the Bow. [. . . ] WARRANTY STATEMENT All EOTECH HOLOgraphic Archery Sights are crafted with pride in the U. S. A. More importantly, they are manufactured with our customer's satisfaction in mind. EOTECH warrants every product to be free from defects in materials and workmanship for a period of one year from the original date of purchase. EOTECH will promptly repair or replace at its option any product that is defective in material or workmanship, without charge. [. . . ]