User manual EPSON EB-696UI INSTALLATION GUIDE (1.0)

[. . . ] XX(XXX) Español Français English Using the Product Safely Safety Instructions For your safety, read all the instructions in this guide before using this product. Incorrect handling that ignores instructions in this guide could damage this product or could result in personal injury or property damage. Read the User's Guide and Safety Instructions for your projector and follow the instructions in these documents. Safety indications The documentation and this product use graphical symbols to show how to use this product safely. [. . . ] If any of the ( ) ) areas are out of focus, adjust the focus After you finish making adjustments, close the air filter cover. N Press the [Esc] button on the remote control or the control panel to remove the guidance screen Sticking the infrared deflectors When installing the Touch Unit, if there are any obstacles at the bottom of the whiteboard such as a frame or trays, touch operations will not operate correctly. If there are any obstacles , stick the infrared deflectors along the bottom edge of the whiteboard before adjusting the position of the projector. 47 Installation Guide c • Do not remove an infrared deflector once it has been stuck in place. Arc Correction When fine-tuning the shape of the projected image, perform Arc Correction. A Turn on the projector, and then press the [Menu] button Using the Remote Control Using the Control Panel b Select Geometry Correction from Settings 48 Installation Guide c Select Arc Correction d Select Arc Correction e Select the side you want to correct f Correct the selected side If the message "Cannot adjust any further. "is displayed while adjusting, you cannot adjust the shape any further in the direction indicated by the gray triangle. G Repeat steps 5 and 6 as needed to adjust any remaining sides Calibrating the pen Check that adjusting the position of the projector is complete before you start calibrating the interactive pen. 41 49 Installation Guide There are two methods available for calibrating the pen; Auto Calibration and Manual Calibration. When calibrating the pen for the first time after installing the projector, perform Manual Calibration for optimum calibration. For the Auto Calibration method, see the projector's User's Guide (on the Document CD-ROM). C When two projectors are installed in parallel and you are using the interactive function, set the multiprojection interactive features before adjusting the pen. S "When two projectors are installed in parallel and you are using the interactive function" p. 92 a Turn on the projector, and then press the [Menu] button Using the Remote Control Using the Control Panel b Select Easy Interactive Function from Extended c Select Manual Calibration 50 Installation Guide d Check that the screen is in focus, and then select Yes A green dot is displayed at the top left of the projection screen. E Touch the center of the dot with the pen tip of the interactive pen The dot disappears and moves to the next position. 51 Installation Guide f Repeat step 5 until all of the dots disappear The dot appears at the top left first and then moves towards the bottom right. C • Check that there are no obstacles between the interactive pen and the Interactive pen receiver ( ). € If you touch the wrong position, press the [Esc] button on the remote control to return to the previous dot. 52 Installation Guide Attaching the Covers a Attach the wall plate covers Install the right cover first. C • Depending on the cable configurations, you may need to cut notches ( ) in the wall plate covers to route the cables. Make sure you do not damage the cables when routing them through the cut holes. € When removing the wall plate cover, press the tabs at the top and bottom of the rear of the wall plate cover with a hexagonal wrench, and pull it forward. [. . . ] Bin) to the computer the PJCONFDATA section the file name, the projector c changecorrectly. You can only useofsingle-byte characters for themay not be able to recognize the file file name. If you need to change the name of the batch setup file, add text after PJCONFDATA. If you Perform "Remove USB device" on your computer, and then disconnect the USB cable c When using OS X, perform "Remove EPSON_PJ". [. . . ]