User manual EPSON EMP-5350

[. . . ] Warning: Never look into the projector lens when the lamp is switched on as the bright light can damage your eyes. Warning: Never open any covers on the projector except the lamp and filter covers. Dangerous electrical voltages inside the projector can cause severe injury. Except as specifically directed in this Owner's Manual, do not attempt to service this product yourself. [. . . ] If you need to raise or lower the image on the screen, extend or retract the two feet at the bottom of the projector as follows: Stand behind the projector and support the front of it while you lift the foot adjust levers above the feet. While lifting the foot adjust levers, raise or lower the projector until the screen image is positioned correctly. To fine-tune the height of the projector, turn the feet clockwise to raise the height or anti-clockwise to lower it. The Resize button allows you to select the projection method for certain types of image input signals from a computer. With images up to XGA (1024 × 768 pixels) size for the EMP-7350/7250 and SVGA (800 × 600 pixels) size for the EMP-5350, you can choose from two projection methods. You can either display the image in the center of the projection area(Window display) or display the image full size(Resize display). You can also choose from two projection methods with images greater than XGA size for the EMP-7350/7250 and SVGA size for the EMP-5350 size: either project a portion of the image or project the entire image in a compressed format. the projector automatically reduces the image size to the projector's maximum resolution. The Resize button cannot be used with images at XGA size for the EMP-7350/7250 and SVGA size for the EMP-5350 resolution. When the image source is Video, the resize button lets you choose an aspect ratio either 4:3 or 16:9. You can use the operation panel on top of the projector or the remote control to perform the following actions: · Turn power on or off · To use the remote control, point it towards the remote control receivers located at the front and back of the projector. To be able to use the remote control as a cordless mouse, connect the mouse cable to the projector and your computer. You can use the remote control up to 10 metres (33 feet) from the projector. Note: The projector may not respond to remote control commands in these conditions: ambient light is too bright; a certain type of fluorescent light is present; a strong light source (such as direct sunlight) shines into the infrared receiver; or other equipment emitting infrared energy is present (such as a radiant room heater). Correct these conditions to use the remote control or control the projector from a computer. To turn on the audio and video output, press either the A/V mute button again or Esc button. pressing the right side of the button enlarges the image , pressing the left side of the button reduces the image. To display a portion of the enlarged image which is outside of the display area, press the Enter button to scroll the image. Use to display special effects that have been assigned in the Effect menu or with the optional ELP Link IV software. Use the enter button to navigate the menus or use the remote as a mouse pointer when the projector is connected to the computer with the main cable and the mouse cable. You can also selects a menu option by pressing the center of this button(Enter). If you press the Enter when a menu or help is displayed, you can access to the next menu or screen. [. . . ] If none of the suggested solutions solves the problem, call your dealer or EPSON Service Centre. If you have problems with the projector, first turn it off and unplug it. If this does not solve the problem, check the warning lights at the top of the projector. See the following pages for information on what to do when you see these warning lights or encounter other specific problems with the projector. [. . . ]