User manual EPSON EMP-5550

[. . . ] DECLARATION of CONFORMITY/DICHIARAZIONE di CONFORMITÀ/ KONFORMITÄSERKLÄUNG/DECLARACIÓN de CONFORMIDAD/DECLARATION de CONFORMITE according to ISO/IEC Guide 22 and EN 45014/secondo la Guida ISO/IEC 22 e EN 450014/entsprechend ISO/ CEI Anleitung 22 und EN 45014/De acuerdo con ISO/IEC Guide 22 y EN 45014/selon les normes ISO/IEC Guide 22 et EN45014 Manufacturer/Produttore/Hersteller/Fabricante/Constructeur SEIKO EPSON CORPORATION Address/Indirizzo/Adresse/Dirección/Adresse 3-5, Owa 3-chome, Suwa-shi, Nagano-ken 392-8502 Japan Representative/Rappresentante/Vertreten durch/Representante/Représentant EPSON EUROPE B. V. J. H. Bavincklaan 5 1183 AT Amstelveen The Netherlands Declares that the Product/Dichiara che il prodotto/Erklärt hiermit, daß das Produkt/Declara que el producto/Déclare que le produit Product name/Nome prodotto/Produktbezeichnung/Nombre del producto/Nom du produit LCD Projector Model name/Nome modello/Modellbezeichnung/Nombre del modelo/Nom du modèle EMP-7500/5550/5500 Conforms to the following directives and Norms/Conforme alle seguenti direttive e Norme/Erfüllt die folgenden Direktiven und Normen/De acuerdo con las directrices y normas siguientes/Conforme aux directives et normes suivantes Directive 89/336/EEC : EN 55022 Class B : EN 61000-3-2 : EN 61000-3-3 : EN 50082-1 Directive 73/23/EEC : EN 60950 July/Juli/Juillet/Juli/Luglio 1998 H. HORIUCHI President of/Presidente della/Der Generaldirektor von/Presidente de/Président de Directeur vanEPSON EUROPE B. V. Printed in Japan 7541689 FCC Compliance Statement For United States Users This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. [. . . ] Computer When you turn off the equipment, do so in the reverse order. Turning the Projector On and Off 1. If computer or video equipment is attached, the computer or video signal is projected. It is especially important that children are not allowed to look into the lens. Caution: When turning the projector on or off with the remote control, be sure to turn the remote control on first with the power switch. ssssss Turning the Equipment On and Off 23 After you press the Power button to turn off the projector, the fan will remain on and the operation indicator will flash orange for about one minute as the projector cools down. operation indicator When the projector has cooled down, the operation indicator stops flashing and remains orange. Note: If you press the Power button to turn the projector back on while the operation indicator is orange, there may be a delay before a projected image appears. Doing so may print the image and cause the afterimage on the panel. Sleep Mode Sleep mode conserves electricity by automatically turning off the lamp after the projector has not been used for 30 minutes. In sleep mode, the projector's operation indicator is orange and only a minimum amount of the projector's circuitry remains on. This conserves electricity, cools the projector, and extends the life of the lamp. When the projector is in sleep mode, you can press the Power button to resume projecting images, or you can unplug the projector's power cord to turn it off. Note: When you don't use the projector, turn off the power switch on the projector. The orange operation indicator turns off. ssss 24 Focusing and Positioning the Screen Image When an image appears on the screen, check that if it is in focus and correctly positioned on the screen. zoom ring focus ring · To focus the image, rotate the focus ring (the outer ring on the projector's lens). Rotate the zoom ring wide to make the image larger, or tele to make it smaller. ssssss Focusing and Positioning the Screen Image 25 If you need to raise or lower the image on the screen, extend or retract the two feet at the bottom of the projector as follows: 1. Stand behind the projector and support the front of it while you lift the foot adjust lever above the feet. While lifting the foot adjust lever, raise or lower the projector until the screen image is positioned correctly. To fine-tune the height of the projector, turn the rear feet clockwise to raise the height or anti-clockwise to lower it. ssss 26 Resize Button The Resize button lets you switch between Resize display and Window display. The Resize button cannot be used with XGA(1024 × 768 pixels) for EMP-7500 and SVGA(800 × 600 pixels) for EMP5550/5500. How to switch With images up to XGA(1024 × 768 pixels) size (for example a 600 × 480 pixels VGA image), press the Resize button alternately. The Resize display changes the VGA(600 × 480) image into the SVGA(800 × 600) image. With images SVGA(800 × 600 pixels) size, the image is displayed with the maximum size in both Resize and Window display. With images larger than SVGA(800 × 600 pixels) size (for example a 1024 × 768 pixels XGA image), you can either select to display a portion of the projected image (Window display) or the entire projected image (Resize display). Each time you press the Resize button, the projected image is displayed in the following order: 1. The projected image is displayed with XGA size, and only the upper of the right image is projected on the screen. After the step 6, press the Resize button again to return to the step 1. ssssss Focusing and Positioning the Screen Image 27 Controlling the Projector You can use the operation panel on top of the projector or the remote control to perform the following actions: · Turn power on and off · Switch between input sources (video - computer) · Access the projector menus to adjust the image, audio, video, and display settings · Control resizing · Control display freeze · Control A/V mute (Cuts off the image and sound temporarily. ) · Adjust or mute audio output · Use custom functions (remote control only) · Use effect functions (for enhancing projected images on the screen; remote control only) ssss 28 Using the Remote Control Source Menu pointer button 2 1 Effects 3 4 5 AV/Mute top multi-purpose button Resize Custom bottom multi-purpose button Freeze Help - Volume + Power Remote control To use the remote control, point it towards the remote control receivers located at the front and back of the projector. [. . . ] If you're displaying video, adjust the Color and Tint (NTSC only) settings on the Video menu. First check that the volume setting is not turned all the way down and that the A/V cable is securely attached to both the projector and the audio source. Press either the Computer or Video button on the remote control or operation panel to select the proper source. ssssss Problems with the Image or Sound 61 ssss 62 s s s s s s s s s s s s s s s 6 Technical Specifications General Type of display Poly-silicon TFT Size of liquid crystal panels 0. 9 inches (22. 9 mm) Resolution Screen size Projection distance Remote control range Internal speaker system Optical aspect ratio Zoom ratio EMP-5550/5500 : 800(h) × 600(v) pixels EMP-7500 : 1024(h) × 768(v) pixels 19 - 230 inch (Tele angle) 25 - 300 inch (Wide angle) 3. 28 - 53. 46 feet (1. 0 - 16. 3 meters) 33 feet (10 meters) 1W + 1W stereo 4 : 3 (horizontal : vertical) 1:1. 3 Projector Lamp Type Power Part number UHE Lamp (Ultra High Efficiency Lamp) 120 W EMP-7500/5500 : ELPLP06 EMP-5550 : ELPLP07 Mechanical Height 3. 6 inches (93 mm) Maximum dimension ssssss 63 Mechanical Width Depth Weight 9. 3 inches (238. 5 mm) Maximum dimension 13. 6 inches (346 mm) Maximum dimension 9. 4 lb (4. 2 kg) Electrical Voltage Rated frequency Power supply 100 - 120 VAC and 200 - 240 VAC ± 10% 50/60 Hz 100 - 120 V, approximately 2. 2 A 50/60 Hz 200 - 240 V, approximately 1. 0 A 50/60 Hz Environmental Temperature Operation: 41 - 95° F (5 - 35° C), non-condensing Storage: 14 - 140° F (-10 - 60° C), non-condensing Humidity Operation: 20 - 80%, non-condensing Storage:10- 90%, non-condensing ssss 64 Supported Monitor Displays (EMP-7500) The projector displays images at a resolution of 1024 × 768 pixels. To display a higher resolution image (1280 × 1024 mode), the projector compresses the image to 1024 × 768 pixels. [. . . ]