User manual EPSON STYLUS OFFICE SX600FW BASIC OPERATION GUIDE

[. . . ] To lower or close the panel, unlock by pulling the lever on the rear until it clicks, and then lower down. After 13 minutes of inactivity, the screen turns black to save energy. Press any button (except P On) to return the screen to its previous state. When you have more than 999 photos on your memory card, the LCD screen displays a message to let you select a group. [. . . ] Select Off to improve the print quality (but your photos print more slowly). *6 Depending on the type of photo, parts of the image other than the eyes may be corrected. You can print school paper with ruled lines or graph paper with or without a photo set as the background. Make sure you have installed software for this printer on your computer and connected following the instructions on the Start Here poster. Remove the memory card from the printer, connect the device, then print photos. On the screen in step 3, you can select to replace ink cartridges even if they are not expended. You can also start this operation by selecting Setup mode, Maintenance, and then Ink Cartridge Replacement. If non-genuine ink cartridges are installed, the ink cartridge status may not be displayed. Print head cleaning uses ink from all cartridges, so clean the print head only if quality declines. If quality does not improve after cleaning four times, leave the printer for at least six hours. Depending on the settings on this printer and the digital camera, some combinations of paper type, size, and layout may not be supported. Some of the settings on your digital camera may not be reflected in the output. Restore Default Settings Reset Fax Send/Receive Settings, Reset Fax Data Settings, Reset Network Settings, Reset All except Network & Fax Settings, Reset All Settings * You can select the LCD screen display format from 1-up with Info, 1-up without Info, and View Thumbnail Images. The printer's ink pads are nearing the end of their service life. Contact Epson support to replace ink pads before the end of their service life. When the ink pads are saturated, the printer stops and Epson support is required to continue printing. (Cause: The data is not available because of a malfunction in the device. Make sure the memory card or storage disk has been inserted correctly. If so, check to see if there is a problem with the card or disk and try again. O Some ink is consumed from all cartridges during the following operations: print head cleaning and ink charging when an ink cartridge is installed. O For maximum ink efficiency, only remove an ink cartridge when you are ready to replace it. The use of non-genuine ink may cause damage that is not covered by Epson's warranties, and under certain circumstances, may cause erratic printer behavior. [. . . ] R & 24 O If the edges of the copy or photo are cropped off, move the original slightly away from the corner. If you cannot solve the problem using the troubleshooting information, contact customer support services for assistance. You can get the contact information for customer support for your area in your online User's Guide or warranty card. If it is not listed there, contact the dealer where you purchased your product. [. . . ]