User manual EVH 5150 III

[. . . ] This symbol warns the user of dangerous voltage levels localized within the enclosure. This symbol advises the user to read all accompanying literature for safe operation of the unit. [. . . ] FMIC amplifiers and loudspeaker systems are capable of producing very high sound pressure levels which may cause temporary or permanent hearing damage. Hazardous voltages may be present within the cabinet even when the power switch is off and the power cord is connected. Therefore, disconnect the power cord from the rear panel power inlet before servicing. FCC COMPLIANCE STATEMENT: This equipment has been tested and found to comply with the limits of Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. This professional all-tube amplifier was developed to meet the exacting specifications of Edward Van Halen, one of the true living legends of rock guitar. The 5150-III amp's flexible feature set allows creation of tones from clean to crunch to full-out distortion, inspiring limitless artistic expression; its roadworthy no-compromise construction promises peak performance for years to come. NOTE: For a cleaner sound from this channel, set the VOLUME knob to its maximum, and start with the GAIN control at a minimum setting, bringing it up to the desired level. SELECT--Push button selects this channel indicated by the green LED below. [. . . ] If the footswitch is disconnected or reconnected after power-up, the amplifier may not function correctly. Power Requirement: 533W Output: 100 Watts RMS into 4, 8, or 16 Ohms Input Impedance: 1M Output Impedance: 4 / 8 / 16 (selectable) Fuses: 100V units, F7A L, 250V; 120V units, F6A L, 250V; 220-240V units, F3A L, 250V; Footswitch (included): 4-button, one / two / three / effects on-off (070926) Tube Complement: Four 6L6WXT output tubes, Eight 12AX7 preamp tubes Weight: 55 lb (25 kg) Height: 10. [. . . ]