User manual FRIGIDAIRE CGIH3047VF

[. . . ] To check if the anti-tip bracket is installed properly, use both arms to grasp the rear edge of the range back. Refer to the anti-tip bracket installation instructions supplied with your range for proper installation. Minimum to wall on either side of 1" range above (25 mm) All dimensions for electrical outlet location are maximum. Dashed cubed area shows where the electrical outlet must be Installed for flush to the wall installation. [. . . ] Mark the floor or wall where left or right side of the range will be located. If rear of range is against the wall or no further than 1-1/4" (32 mm) from wall when installed, you may use the wall or floor mount method. If molding is installed and does not allow the bracket to fit flush against the wall, remove molding or mount bracket to the floor. For wall mount, locate the bracket by placing the back edge of the template against the rear wall and the side edge of template on the mark made referencing the side of the range. place bracket on top of template and mark location of the screw holes in wall. If rear of range is further than 1-1/4" (32 mm) from the wall when Level and Position Range - Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearance of 1/8" (3 mm) is required between the bottom of the range and the leveling leg to allow room for the bracket. Visually check that rear leveling leg is inserted into and fully secured by the Anti-Tip Bracket by removing lower panel or storage drawer. For models with a warmer drawer or broiler compartment, grasp the top rear edge of the range and carefully attempt to tilt it forward. Power supply cord with 4-prong grounding plug It is the personal responsibilty of the consumer to have the appropiate outlet with the correct, properly grounded wall receptacle installed by a qualified electrician. Failure to follow this warning may cause serious injury, fire, or death. Plug the range power cable (4 conductors) into a 4 conductor range outlet. Outlet must be properly grounded and in accordance with the Canadian Electrical Code (CSA Standard (C22. 1 Part 1 -- latest edition) -- and any local electrical code requirements. Locate outlet 6" (152 mm) above the floor in the wall behind the range. grounding Instructions For personal safety, this appliance must be properly grounded. For maximum safety, the power cord must be plugged into an electrical outlet that is correct voltage, is correctly polarized and properly grounded in accordance with local codes. The serial plate is located on the right-hand surface of the oven front frame at the storage or warmer drawer; or the lower panel area. When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your range. Your serial plate also tells you the Kilowatt rating (power requirements) and Voltage ratings. [. . . ] If removing the range is necessary for cleaning or maintenance, disconnect the electrical power supply. If the electrical supply is inaccessible, lift the unit slightly at the front and pull out away from the wall. Reinstall in reverse order making sure to level the range and check electrical connections. Before You Call for Service Read the "Before You Call" and operating instruction sections in your Use & Care Manual. [. . . ]