User manual FRIGIDAIRE DRYER

[. . . ] To reduce the risk of fire, electric shock or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS in your dryer Owner's Guide before operating this appliance. A suitable dryness level and options will automatically be displayed for each cycle. To change the dryness level, press DRYNESS until the desired selection is made. [. . . ] It provides approximately 20 minutes of tumbling followed by a 10-minute cool down period. Touch Up Select Touch Up to help remove wrinkles from clean and dry items that were not taken from the dryer at the end of the cycle, have been stored in crowded closets or drawers, or unpacked from luggage following a trip. It provides approximately 10 minutes of tumbling followed by a 5-minute cool down period. Timed Dry To manually select the drying time for any load, turn the knob to a numbered setting. Drying times from 15 to 90 minutes are available in 15-minute increments. For best results, follow the fabric care label instructions on items to be dried. Cycle Selection Medium is recommended for wrinkle free, permanent press and For best results, follow the fabric care label instructions on items lightweight fabrics. The load No Heat should only be used with a Timed Dry setting to dry will automatically be dried at the selected temperature to the items containing feathers, down, foam rubber, plastics or rubdesired dryness level. The dryer senses the moisture level of the ber-like materials; to freshen clothing, pillows or blankets; or to load as it tumbles through heated air. Note: Using No Heat in any Auto Dry cycle will result in long drying times and /or wet loads at the end of the cycle. To avoid fire hazard, do not use heat to dry items containing feathers or down, foam rubber, plastics, or similarly textured, rubber-like materials. A suitable combination of dryness level and options will automatically be displayed for each cycle. Those adjustments will automatically be remembered each time that cycle is selected. If a dryness level or option is not recommened for a cycle, the indicator will not light. If changes are attempted after the cycle starts, the status lights will blink and the signal will beep 3 times. Dryness Level To change the dryness level, press DRYNESS until the desired selection is made. [. . . ] (Control Lock) To avoid having someone accidentally start or stop the dryer, press OPTIONS and Select at the same time and hold for about 10 seconds until the (Control Lock) lights up. to unlock the controls , press and hold OPTIONS and Select for about 10 seconds. Status Lights The following indicators may be lighted during the cycle: · These temperatures, dryness levels and options are available with the following cycles: Towels Estimated Cycle Duration *** Temperatures High Medium Low No Heat Dryness Level More Dry Normal Dry Less Dry Damp Dry Options Press Saver Cycle Signal * Factory setting not recommended not recommended not recommended not recommended recommended 60 minutes Normal 50 minutes Perm Press 40 minutes Delicate 20 minutes Quick ** Touch Up ** Timed Dry Dryness level and factory settings. [. . . ]