User manual FRIGIDAIRE ELECTRIC RANGE WITH ES 1000 SERVICE DATASHEET

[. . . ] The following are examples, but without limitation, of such practices. Before servicing or moving an appliance remove power cord from electrical outlet, trip circuit breaker to OFF, or remove fuse. GROUNDING: The standard color coding for safety ground wires is GREEN or GREEN WITH YELLOW STRIPES. [. . . ] The adjustments made will not change the self-cleaning temperature. Electronic Oven Control Fault Code Descriptions Fault Code F10 Likely failure condition/cause Runaway temperature. Oven heats when no cook cycle is programmed. Suggested Corrective Action If Oven is cold: 1. If fault code is present with cold oven test oven temperature sensor probe circuit resistance. If temperature sensor probe circuit is good but fault code remains when oven is cold replace the EOC. If oven is severely overheating/heating when no cook cycle is programmed test oven temperature sensor probe circuit resistance using the RED scale found in the service tech sheet. Also verify that the temperature sensor probe in properly installed in the oven cavity. If oven continues to heat when the power is reapplied, replace the EOC. NOTE: Severe overheating may require the entire oven to be replaced should damage be extensive. Reset power supply to range - Disconnect power, wait 30 seconds and reapply power. If keyboard ciruits check good replace the EOC. F11 Shorted keypad or selector switch. F12 F13 F14 EOC Internal software error or failure. Keyboard tail failure. Disconnect power, wait 30 seconds and reapply power. Check/reseat ribbon harness connections between keyboard touch panel and EOC. . (F30) Check resistance at room temperature & compare to RTD Sensor resistance chart. (F31) Check resistance at room temperature, if less than 500 ohms, replace RTD Sensor Probe. Check for shorted Sensor Probe harness between EOC & Probe connector. Usually this failure code would only appear if the EOC has been replaced with an incorrect version. [. . . ] If motor runs with test cord check continuity of wire harness to lock motor terminals. If harness is good replace the EOC. F66 F68 F69 F90 F91 F92 F93 F94 F95 Tech Sheet Abbreviations and Terminology EOC = Electronic Oven Control RTD = Resistance Temperature Device. (Temp Probe or VSC = Variable Speed Control Temp Sensor) PS = Power Supply board (PS1 , PS2, etc. ) TCO = Thermal Cut Out also "Thermo Disc" or "Thermal Limiter" Keypad Test Matrix IMPORTANT DO NOT REMOVE THIS BAG OR DESTROY THE CONTENTS WIRING DIAGRAMS AND SERVICE INFORMATION ENCLOSED REPLACE CONTENTS IN BAG p/n 316904402en (0905) Left side Right side View: control membrane overlay from front To test keypad function check for continuity between indicated pin locations while pressing keypad. [. . . ]