User manual FRIGIDAIRE ES 200 SERVICE DATASHEET
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual FRIGIDAIRE ES 200. We hope that this FRIGIDAIRE ES 200 user guide will be useful to you.
Manual abstract: user guide FRIGIDAIRE ES 200SERVICE DATASHEET
Detailed instructions for use are in the User's Guide.
[. . . ] SERVICE DATA SHEET
Electric Ranges with ES 200/205/300 & 305 Electronic Oven Controls NOTICE - This service data sheet is intended for use by persons having electrical and mechanical training and a level of knowledge of these subjects generally considered acceptable in the appliance repair trade. The manufacturer cannot be responsible, nor assume any liability for injury or damage of any kind arising from the use of this data sheet. [. . . ] · All uninsulated electrical terminals, connectors, heaters, etc. · All safety grounds (both internal and external) are correctly and securely reassembled.
ELECTRONIC OVEN CONTROL (REAR VIEW)
OVEN CALIBRATION
Set the electronic oven control for normal baking at 350°F. Within 5 seconds of setting 550°F, press and hold the bake pad for approximately 15 seconds until a single beep is heard (longer may cause F11 shorted keypad alarm). Use the slew keys to adjust the oven temperature up or down 35°F in 5°F increments. Once the desired (-35° to 35°) offset has been applied, press STOP/CLEAR.
3. The adjustments made will not change the Self-Cleaning cycle temperature.
SIMMER SELECT PCB (some models) ELECTRONIC OVEN CONTROL FAULT CODE DESCRIPTIONS
Fault Code
F10 F11 F12 F13
4.
Likely Failure Condition/Cause
Runaway Temperature. Bad EEPROM Identification/Checksum error.
Suggested Corrective Action
1. If oven continues to overheat when the power is reapplied, replace EOC. Severe overheating may require the entire oven to be replaced should damage be extensive. (F11, 12 & 13) Disconnect power, wait 30 seconds and reapply power. (F11, 12 & 13) If fault returns upon power-up, replace EOC.
F30
Open probe connection. (F30 or F31) Check resistance at room temperature & compare to RTD Sensor resistance chart. [. . . ] (F92, 93 & 94) Check oven door Light Switch - if open, replace Switch. If all situations above do not solve problem, replace EOC.
RESISTANCE TEMPERATURE DECTECTOR
CIRCUIT ANALYSIS MATRIX
RTD SCALE Temperature (°F) Resistance (ohms) 1000 ± 4. 0 1091 ± 5. 3 1453 ± 8. 9 1654 ± 10. 8 1852 ± 13. 5 2047 ± 15. 8 2237 ± 18. 5 2697 ± 24. 4
IMPORTANT
DO NOT REMOVE THIS BAG OR DESTROY THE CONTENTS
WIRING DIAGRAMS AND SERVICE INFORMATION ENCLOSED
32 ± 1. 9 75 ± 2. 5 250 ± 4. 4 350 ± 5. 4 450 ± 6. 9 550 ± 8. 2 650 ± 9. 6 900 ± 13. 6
REPLACE CONTENTS IN BAG
p/n 316441437 (0510)
TROUBLESHOOTING DIAGRAM
TROUBLESHOOTING SCHEMATIC [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE FRIGIDAIRE ES 200
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual FRIGIDAIRE ES 200 will begin.