User manual FRIGIDAIRE FAD301NUD

[. . . ] Do not allow them to sit or stand on the appliance. WARNING Electrical Information Power supply cord with 3-prong grounding plug For your safety and protection, this dehumidifier is equipped with a three-prong grounding plug on the power cord. Do not, under any circumstances, cut or remove the round ground prong from the plug. Your dehumidifier must be plugged directly into a properly grounded and polarized three-prong receptacle. lf the wall receptacle you intend to use will not accept a three-prong plug, or if you are not sure the outlet is adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician install the proper outlet according to the National Electrical Code and applicable local codes and ordinances. [. . . ] This prevents overheating of the compressor and possible circuit breaker tripping. Make sure the tank is fitted correctly otherwise unit will not turn on. 2009 Electrolux Home Products, Inc. All rights reserved. 3 Operating Instructions Operating Instructions Allow the unit to reach room temperature before operating. To begin operating the dehumidifier, follow these steps: NOTE: Unit must be upright for one hour prior to operating. Note the POWER indicators will illuminate. NOTE: If the "BUCKET FULL" light is on, remove the bucket and re-install to reset the float switch. 2. To turn the unit on rotate the knob until it points to the CONTINUOUS setting. It is recommended you leave the unit running in the CONTINUOUS setting for the first three or four days until any sweating and dampness odors have ceased. 3. After a few days when the Relative Humidity has declined, rotate the HUMIDITY knob to a desired point on the dial so the room is kept at a comfortable concentration. The unit will cycle on and off keeping the desired level of comfort. 4 2009 Electrolux Home Products, Inc. All rights reserved. Operating Instructions Operating Instructions (continued) 1. To shut the unit down, rotate the humidity knob to the OFF position. NOTE: While the power indicator lit, rotate the humidity knob to the OFF position or removing the plug will extinguish this light. Removing Collected Water 1. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate. b. Do not move the unit at this time otherwise water may spill on the floor. Remove the bucket as shown in the photographs below and empty the bucket. WARNING Discard water from bucket. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again. You should hear a click when the bucket is in the correct position If the bucket full light does not extinguish, check that the float is correctly snapped in place as indicated by the diagram. 2009 Electrolux Home Products, Inc. All rights reserved. 5 Operating Instructions, Care and Cleaning & Storage Removing Collected Water (continued) 2. For continuous drainage operation, you will need a garden hose and a drain nearby to discharge the water into. (fig. 1) Insert the female threaded end of the hose onto the drain connector of the unit. (fig. 2) Screw the garden hose onto the threaded portion of the drain connector. Direct the hose toward the drain, making sure that there are no kinks that will stop the water flowing. (fig. 4) Select the desired humidity setting and fan speed on the unit for continuous draining to start. fig. If there is a small leak then replace the hose gasket and re-tighten the hose. [. . . ] If You Need Keep your receipt, delivery slip, or some other appropriate payment record to establish the warranty period Service should service be required. If service is performed, it is in your best interest to obtain and keep all receipts. Service under this warranty must be obtained by contacting Electrolux at the addresses or phone numbers below. In the USA, your appliance is warranted by Electrolux Major Appliances North America, a division of Electrolux Home Products, Inc. [. . . ]