User manual FRIGIDAIRE FAD504DUD

[. . . ] Do not allow them to sit or stand on the appliance. WARNING Electrical Information Power supply cord with 3-prong grounding plug For your safety and protection, this dehumidifier is equipped with a three-prong grounding plug on the power cord. Do not, under any circumstances, cut or remove the round ground prong from the plug. Your dehumidifier must be plugged directly into a properly grounded and polarized three-prong receptacle. lf the wall receptacle you intend to use will not accept a three-prong plug, or if you are not sure the outlet is adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician install the proper outlet according to the National Electrical Code and applicable local codes and ordinances. [. . . ] After you have set the desired humidity, the readout will display the actual room humidity. If at any time you want to return to the CONTINUOUS Mode, pressing the HUMIDITY button will lower the Relative Humidity through the 5% increments until the display reads CO. 4. You can also use the FAN SPEED button to change the fan speed to HIGH or LOW. At this time refer to the care and cleaning section to remove and clean the filter. Once the filter has been cleaned and replaced, simply press the FILTER button to extinguish the light. 2009 Electrolux Home Products, Inc. All rights reserved. 5 Operating Instructions Operating Instructions (continued) 6. The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0. 5 hour to 24 hours. If the unit is running, then selecting Timer will turn the unit off in the hours that will be set (Delay Stop). If the unit is off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start). TIMER setting: First press TIMER button, then adjust timer setting, by tapping or holding the or button to change the delay timer at 0. 5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining (8, 7. 5, 7, etc. ) until the unit either starts or stops. For the Delay Start, the fan speed and humidity maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER button again at any time will stop the TIMER function. The Delay Start/Stop Feature will work until the unit either starts or stops. Before entering TIMER setting, make sure power is being supplied to the unit. Before entering TIMER setting, make sure pressing HUMIDITY or button sets one desired room humidity first. 7. If the display reads "AS" or "ES" , a sensor has failed. Contact your Authorized Frigidaire Service Center. 6 2009 Electrolux Home Products, Inc. All rights reserved. Operating Instructions Removing Collected Water 1. When the bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate. b. Do not move the unit at this time otherwise water may spill on the floor. Remove the bucket as shown in the photographs below and empty the bucket. WARNING Discard water from bucket. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again. You should hear a click when the bucket is in the correct position If the bucket full light does not extinguish, check that the float is correctly snapped in place as indicated by the diagram. 2009 Electrolux Home Products, Inc. All rights reserved. 7 Operating Instructions, Care and Cleaning & Storage Removing Collected Water (continued) 2. [. . . ] If You Need Keep your receipt, delivery slip, or some other appropriate payment record to establish the warranty period Service should service be required. If service is performed, it is in your best interest to obtain and keep all receipts. Service under this warranty must be obtained by contacting Electrolux at the addresses or phone numbers below. In the USA, your appliance is warranted by Electrolux Major Appliances North America, a division of Electrolux Home Products, Inc. [. . . ]