User manual FRIGIDAIRE FAD704TDD0

[. . . ] Do not allow them to sit or stand on the appliance. WARNING Electrical Information Power supply cord with 3-prong grounding plug For your safety and protection, this dehumidifier is equipped with a three-prong grounding plug on the power cord. Do not, under any circumstances, cut or remove the round ground prong from the plug. Your dehumidifier must be plugged directly into a properly grounded and polarized three-prong receptacle. lf the wall receptacle you intend to use will not accept a three-prong plug, or if you are not sure the outlet is adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician install the proper outlet according to the National Electrical Code and applicable local codes and ordinances. [. . . ] TIMER setting: First press TIMER button, then to adjust timer setting, tap or hold the or button to change the delay timer at 0. 5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining (8, 7. 5, 7, etc. ) until the unit either starts or stops. For the Delay Start, the fan speed and humidity maintained will be the same as previously setting. After TIMER setting finishs, pressing TIMER button again at any time will cancel the TIMER function. The Delay Start/Stop Feature will work until the unit either starts ro stops. Once that happens the above steps have to be repeated again. NOTE: 1. Before entering TIMER setting, the power indicator must be lit to make sure power is being supplied to the unit. Before entering TIMER setting, make sure first pressing HUMIDITY or button sets one desired room humidity. 7. To shut the unit down, press the ON/OFF button. NOTE: While the unit is plugged in the power indicator will remain lit. Only removing the plug will extinguish this light. 2009 Electrolux Home Products, Inc. All rights reserved. 5 Operating Instructions Fault Codes 1. If the display reads "AS" or "ES" , a sensor has failed. Contact your Authorized Frigidaire Service Center. Removing Collected Water 1. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate. b. Do not move the unit at this point otherwise water may spill on the floor. Remove the bucket as shown in the photographs below and empty the bucket. WARNING Discard water from bucket. Replace the empty bucket back into the unit and once seated correctly the unit will start up again. You should hear a click when the bucket is in the correct position 6 2009 Electrolux Home Products, Inc. All rights reserved. Operating Instructions Removing Collected Water (continued) If the bucket full light does not extinguish, check that the float is correctly snapped in place as indicated by the diagram. 2. For constant drainage operation, you will need a garden hose and a drain nearby to discharge the water into. Lift up the side flap located on the right side of the unit as Iooking from the front. (fig. 1) Insert the female threaded end of the hose through the opening. (fig. 2) Screw the garden hose onto the threaded portion of the tray underneath the bucket opening. Direct the hose toward the drain, making sure that there are no kinks that will stop the water flowing. [. . . ] If You Need Keep your receipt, delivery slip, or some other appropriate payment record to establish the warranty period Service should service be required. If service is performed, it is in your best interest to obtain and keep all receipts. Service under this warranty must be obtained by contacting Electrolux at the addresses or phone numbers below. In the USA, your appliance is warranted by Electrolux Major Appliances North America, a division of Electrolux Home Products, Inc. [. . . ]